Search

The five papers in this special section are extended versions of papers presented at the 5th International Conference on Mechatronics (ICM 2009), held in Malaga, Spain in April 2009. [ABSTRACT FROM AUTHOR]

This paper describes the configuration, modeling, and control of a fuel cell (FC)-battery-powered hybrid system for the Metro Centro tramway in Seville, Spain. The proposed hybrid system presents a polymer electrolyte membrane FC as the primary energy source and a nickel-metal hydride cell battery as the secondary energy source, which supplements the output of the FC during tramway acceleration or whenever else needed and cruise and for energy recovery during braking. The tramway presents a traction system which is composed of four traction induction motor drives. The hybrid system also supplies the power for the auxiliary services. The power conditioning system is composed of two converters: 1) a boost-type unidirectional dc/dc converter for the FC and 2) a boost-type bidirectional dc/dc converter for the battery. The energy management system (EMS) of the hybrid tramway determines the reference signals for the electric motor drives, FC, and power converters in order to regulate accurately the power from the two electrical sources. EMS also determines the reference signal for energy dissipation in braking chopper when required during regenerative braking. In this paper, the proposed hybrid system is evaluated for the real driving cycle of the tramway. The results demonstrate the hybrid system capability to meet appropriate driving cycle. [ABSTRACT FROM PUBLISHER]

The increasing installed wind power capacity has caused wind power generation to become a significant percentage of the entire electric power generation. As a consequence, the power system operators have included wind power plants regulation to improve the control of the overall power system, both in steady-state and transient operation. Therefore, wind power systems are required to verify the grid connection requirements stated by the power system operators. In presence of grid voltage dips, the low voltage ride-through (LVRT) requirement compliance produces a mismatch between the generated active power and the active power delivered to the grid. The conventional solution assumes that the active power surplus is dissipated in a dc-link resistor. In this paper, a control scheme for the back-to-back neutral-point-clamped converter is proposed. Under grid voltage dip, the controllers for generator-side and grid-side converters work concurrently to meet the LVRT requirement by storing the active power surplus in the turbine-generator mechanical system inertia while keeping constant the dc-link voltage. Simulation and experimental results verify the proposed control scheme. [ABSTRACT FROM PUBLISHER]