Search

Direct modulation principle is widely used in modular multilevel converters (MMCs) for its simplicity and natural stability. However, it results in strong active and reactive power coupling. This paper carefully analyzes and identifies four power coupling paths and two power influence factors with the direct modulation principle. Full power decoupling of the MMC can be realized by cutting off the derived coupling paths and compensating the influence factors. However, this will further deteriorate the already poor damping of the MMC and significantly increase dc-bus current fluctuations. To solve this problem, the sources resulting in poor damping are identified and then a new closed-loop dc-bus current controller is incorporated into the control system. Finally, the proposed power decoupling strategy with the newly designed current controller realizes completely decoupled power regulation, avoids overload operation, and obviously improves the dynamic performance of the MMC. Furthermore, it increases the stability of the MMC system under all possible operation conditions. The proposed control strategy is confirmed by experimental results. [ABSTRACT FROM AUTHOR]

High penetration of renewable energies through fast-response power converters results in a considerable displacement of conventional synchronous generators and losing of system inertia for frequency control. Modular multilevel converters (MMCs) can be employed serving as an interface between the large-scale renewable generation and power grids. In a microgrid with high shares of renewables integrating through MMCs, submodule (SM) capacitors can be used as energy storage to provide a degree of synthetic inertia for system frequency support. This paper quantitatively exploits the MMC synthetic inertia in a microgrid with flexible renewable penetration levels. An MMC inertia coefficient concept is proposed. It is mainly affected by the penetration ratio, the SM capacitance, and the modulation index of an MMC, with the system operation constraints. According to the analysis, a substantial portion of system inertia can be provided by properly designed MMCs. Detailed MMC frequency control loops are presented. The capacitor average voltage is proportionally linked to the frequency deviation, in order to flexibly adjust the capacitor energy during frequency events. The MMC output active power is deliberately and simultaneously regulated according to the capacitor energy change rate. By controlling the MMC capacitor voltage, dc side power, and output active power, an amount of energy can be released or absorbed by SM capacitors to improve the system frequency response during the frequency event transients, while the renewable generation is scarcely influenced. The proposed concept is experimentally verified and the results show that, with proper system parameters and control loops, the line frequency deviation and the rate of change of frequency can be significantly reduced. Good agreements of the system frequency characteristics have been achieved between the theoretical calculation and experimental results. [ABSTRACT FROM AUTHOR]