Search

State-of-charge (SoC) imbalance and bus voltage deviation are two of the main problems in autonomous dc microgrids. Based on this concern, this paper presents an improved dual-quadrant SoC weighted control strategy and a distributed optimization control method to achieve SoC balance, ensuring accurate power-sharing and bus voltage recovery. Firstly, this paper couples the injected/released power with the current SoC and observed average SoC value to weight the droop coefficient, which is based on the charge/discharge mode for the energy storage system. Then a secondary controller is designed based on distributed optimal control to eliminate the bus voltage deviation caused by the line impedance difference. The proposed optimal control method optimizes the average bus voltage to the nominal value and achieve accurate power-sharing by constructing the correlated variables and voltage independent intermediate variables exchanged among bulk energy storage units (ESUs). Since the voltage observer cannot accurately observe the true average bus voltage under the communication delay, the proposed distributed optimal control method without the voltage observer can ensure that the average bus voltage is optimized to the nominal value, thus improving the robustness of the control system. Finally, the correctness and effectiveness of the proposed method are verified in Simulink/MATLAB. [ABSTRACT FROM AUTHOR]

This article investigates the current sharing and voltage regulation problem of a DC microgrid by a distributed supervisory control method. In the existing secondary control methods, current sharing feedback control loop and voltage regulation feedback control loop are linearly integrated to shift the droop equation. However, the linear combination of two loops may easily offset the control effect of each other, as the control dimension is less than the objective dimension. This fact motivates us to design a distributed supervisory secondary control (DSSC) scheme to achieve a more flexible configuring of each converter. The DSSC consists of two candidate controllers and a supervisor. The two controllers refer to current sharing configuring and DC bus voltage regulation respectively, and the supervisor is to orchestrate the switching between candidate controllers based on the system environment of DC microgrid. Under the proposed DSSC, each converter selects to configure the current sharing or regulates the DC bus voltage according to its need. Theoretical stability analysis is rigorously conducted. Finally, both simulation and experiment results are presented to demonstrate the effectiveness of DSSC. [ABSTRACT FROM AUTHOR]