Search

In conventional multi-user multiple-input multiple-output (MU-MIMO) systems with frequency division duplexing (FDD), channel acquisition and precoder optimization processes have been designed separately although they are highly coupled. This paper studies an end-to-end design of downlink MU-MIMO systems which include pilot sequences, limited feedback, and precoding. To address this problem, we propose a novel deep learning (DL) framework which jointly optimizes the feedback information generation at users and the precoder design at a base station (BS). Each procedure in the MU-MIMO systems is replaced by intelligently designed multiple deep neural networks (DNN) units. At the BS, a neural network generates pilot sequences and helps the users obtain accurate channel state information. At each user, the channel feedback operation is carried out in a distributed manner by an individual user DNN. Then, another BS DNN collects feedback information from the users and determines the MIMO precoding matrices. A joint training algorithm is proposed to optimize all DNN units in an end-to-end manner. In addition, a training strategy which can avoid retraining for different network sizes for a scalable design is proposed. Numerical results demonstrate the effectiveness of the proposed DL framework compared to classical optimization techniques and other conventional DNN schemes. [ABSTRACT FROM AUTHOR]

Multiple-input multiple-output orthogonal frequency division multiplexing (MIMO-OFDM), a fundamental transmission scheme, promises high throughput and robustness against multipath fading. However, these benefits rely on the efficient detection strategy at the receiver and come at the expense of the extra bandwidth consumed by the cyclic prefix (CP). We use the iterative orthogonal approximate message passing (OAMP) algorithm in this paper as the prototype of the detector because of its remarkable potential for interference suppression. However, OAMP is computationally expensive for the matrix inversion per iteration. We replace the matrix inversion with the conjugate gradient (CG) method to reduce the complexity of OAMP. We further unfold the CG-based OAMP algorithm into a network and tune the critical parameters through deep learning (DL) to enhance detection performance. Simulation results and complexity analysis show that the proposed scheme has significant gain over other iterative detection methods and exhibits comparable performance to the state-of-the-art DL-based detector at a reduced computational cost. Furthermore, we design a highly efficient CP-free MIMO-OFDM receiver architecture to remove the CP overhead. This architecture first eliminates the intersymbol interference by buffering the previously recovered data and then detects the signal using the proposed detector. Numerical experiments demonstrate that the designed receiver offers a higher spectral efficiency than traditional receivers. Finally, over-the-air tests verify the effectiveness and robustness of the proposed scheme in realistic environments. [ABSTRACT FROM AUTHOR]

Massive multiple-input multiple-output can obtain more performance gain by exploiting the downlink channel state information (CSI) at the base station (BS). Therefore, studying CSI feedback with limited communication resources in frequency-division duplexing systems is of great importance. Recently, deep learning (DL)-based CSI feedback has shown considerable potential. However, the existing DL-based explicit feedback schemes are difficult to deploy because current fifth-generation mobile communication protocols and systems are designed based on an implicit feedback mechanism. In this paper, we propose a DL-based implicit feedback architecture to inherit the low-overhead characteristic, which uses neural networks (NNs) to replace the precoding matrix indicator (PMI) encoding and decoding modules. By using environment information, the NNs can achieve a more refined mapping between the precoding matrix and the PMI compared with codebooks. The correlation between subbands is also used to further improve the feedback performance. Simulation results show that, for a single resource block (RB), the proposed architecture can save 25.0% – 40.0% of overhead compared with the Type I codebook under different antenna configurations. For a wideband system with 52 RBs, overhead can be saved by 30.7% and 48.0% compared with the Type II codebook when ignoring and considering extracting subband correlation, respectively. [ABSTRACT FROM AUTHOR]

A deep learning assisted sum-product detection algorithm (DL-SPDA) for faster-than-Nyquist (FTN) signaling is proposed in this paper. The proposed detection algorithm works on a modified factor graph which concatenates a neural network function node to the variable nodes of the conventional FTN factor graph to approach the maximum a posterior probabilities (MAP) error performance. In specific, the neural network performs as a function node in the modified factor graph to deal with the residual intersymbol interference (ISI) that is not considered by the conventional detector with a limited complexity. We modify the updating rule in the conventional sum-product algorithm so that the neural network assisted detector can be complemented to a turbo equalization receiver. Furthermore, we propose a compatible training technique to improve the detection performance of the proposed DL-SPDA with turbo equalization. In particular, the neural network is optimized in terms of the mutual information between the transmitted sequence and the extrinsic information. We also investigate the maximum-likelihood bit error rate (BER) performance of a finite length coded FTN system. Simulation results show that the error performance of the proposed algorithm approaches the MAP performance, which is consistent with the analytical BER. [ABSTRACT FROM AUTHOR]

The key role of spectrum sensing in cognitive radios attracted substantial research attention to improve the performance of detectors. We consider a general model for the receiver noise with the potential of generalization towards modeling noise in various environments. This general noise model describes accurately noise characteristics ranging from the Gaussian noise to the severe impulsive noise. However, many previous studies are based on the ideal Gaussian noise, and they cannot capture the non-Gaussian models. To provide a robust detector against different behaviors of the noise in various environments, we employ a convolutional neural network (CNN) compatible with different noise models. The proposed CNN detector is data-driven, and due to its single-dimensional input layer, it is consistent with the received signal and requires no pre-processing. The likelihood ratio test (LRT), the Wald, and the Rao tests for this problem are derived to enrich the paper with comparative evaluations of the proposed CNN and conventional model-based approaches and other neural networks. Although various simulated scenarios substantiate the general superiority and robustness of the CNN-based against impulsive noise and mismatch of parameters, it requires higher computational complexity than other discussed detectors. [ABSTRACT FROM AUTHOR]

Channel estimation is crucial to modern wireless systems and becomes more and more challenging with the growth of user throughput in sub-6 GHz multiple input multiple output configuration. Plenty of literature spends great efforts in improving the estimation accuracy, while the interpolation schemes are overlooked. To deal with this challenge, we exploit the super-resolution image recovery scheme to model the non-linear interpolation mechanisms. Moreover, in order to extend the estimation scheme into the non-stationary environment which is especially attractive in the coming 6G, we utilize the recurrent network structure to approximate the non-linear channel statistic correlation to model the non-stationary behavior which is difficult to accomplish in the theoretical way. To make it more practical, we offline generate numerical channel coefficients according to the statistical channel models to train the neural networks and directly apply them in different environments. As shown in this paper, the proposed unified super-resolution based channel estimation scheme can outperform the conventional approaches in both stationary and non-stationary scenarios, which we believe can significantly change the current channel estimation method in the near future. [ABSTRACT FROM AUTHOR]

Predicting the millimeter wave (mmWave) beams and blockages using sub-6 GHz channels has the potential of enabling mobility and reliability in scalable mmWave systems. Prior work has focused on extracting spatial channel characteristics at the sub-6 GHz band and then use them to reduce the mmWave beam training overhead. This approach still requires beam refinement at mmWave and does not normally account for the different dielectric properties at the different bands. In this paper, we first prove that under certain conditions, there exist mapping functions that can predict the optimal mmWave beam and blockage status directly from the sub-6 GHz channel. These mapping functions, however, are hard to characterize analytically which motivates exploiting deep neural network models to learn them. For that, we prove that a large enough neural network can predict mmWave beams and blockages with success probabilities that can be made arbitrarily close to one. Then, we develop a deep learning model and empirically evaluate its beam/blockage prediction performance using a publicly available dataset. The results show that the proposed solution can predict the mmWave blockages with more than 90% success probability and can predict the optimal mmWave beams to approach the upper bounds while requiring no beam training overhead. [ABSTRACT FROM AUTHOR]

Emerging recently as a novel concept in communication system design, end-to-end learning introduces deep neural networks (NNs) to represent the transmitter and receiver functions. Consequently, the whole system can be interpreted as an autoencoder (AE), which can be optimized from a holistic approach through a data-driven training method. Until now, the AE technique is mainly developed for point-to-point communication scenarios. In this paper, we aim to develop a novel NN-based AE scheme for relay-assisted cooperative communication systems. Specifically, three NN components are constructed to learn the behavior of the transmitter, relay node, and receiver, respectively. As the conventional end-to-end training is inapplicable, a novel two-stage training approach is proposed to indirectly solve the end-to-end training problem. The implicit approximations involved are analytically expressed based on information theory, offering insights on the achievable performance with the proposed training method. The proposed AE model eliminates the need for channel state information and noise variance of any link, and is adaptive to the variation in the input block length. Simulation results verify its advantages over the conventional decode-and-forward (DF) and amplify-and-forward (AF) schemes in various scenarios. [ABSTRACT FROM AUTHOR]

This paper deals with the use of emerging deep learning techniques in future wireless communication networks. It will be shown that the data-driven approaches should not replace, but rather complement, traditional design techniques based on mathematical models. Extensive motivation is given for why deep learning based on artificial neural networks will be an indispensable tool for the design and operation of future wireless communication networks, and our vision of how artificial neural networks should be integrated into the architecture of future wireless communication networks is presented. A thorough description of deep learning methodologies is provided, starting with the general machine learning paradigm, followed by a more in-depth discussion about deep learning and artificial neural networks, covering the most widely used artificial neural network architectures and their training methods. Deep learning will also be connected to other major learning frameworks, such as reinforcement learning and transfer learning. A thorough survey of the literature on deep learning for wireless communication networks is provided, followed by a detailed description of several novel case studies wherein the use of deep learning proves extremely useful for network design. For each case study, it will be shown how the use of (even approximate) mathematical models can significantly reduce the amount of live data that needs to be acquired/measured to implement the data-driven approaches. Finally, concluding remarks describe those that, in our opinion, are the major directions for future research in this field. [ABSTRACT FROM AUTHOR]