Search

This paper deals with the design of single-stage differential low-noise amplifiers for ultra-wideband (UWB) applications, comparing state-of-the-art planar bulk and silicon-on-insulator (SOI) FinFET CMOS technologies featuring 45-nm gate length. To ensure a broadband input impedance matching, the gm-boosted topology has been chosen. Furthermore, the amplifiers have been designed to work over the whole UWB band (3.1-10.6 GHz), while driving a capacitive load, which is a realistic assumption for direct conversion receivers where the amplifier directly drives a mixer. The simulations (based on compact models obtained from preliminary measurements) highlight that, at the present stage of the technology development, the planar version of the circuit appears to outperform the FinFET one. The main reason is the superior cutoff frequency of planar devices in the inversion region, which allows the achievement of noise figure and voltage gain comparable to the FinFET counterpart, with a smaller power consumption. [ABSTRACT FROM AUTHOR]

This paper presents a modular and comprehensive nonlinear time-domain behavioral model for phase-locked loops (PLLs) that are suitable for analyzing the impact on the output signal of the noise contribution and nonidealities of the constituent building blocks. The model building blocks are described by Simulink submodels and can be configured to implement different PLL topologies. Postprocessing of the PLL output provides the PLL phase noise and spur-to-carrier-ratio performances. The calculated phase-noise spectra are compared with those obtained with the well-known linear model and with measurements. To show the flexibility of this approach, many case studies are reported; among them, the analysis of the spurs due to charge pump mismatch and the transient phase noise, and spurs performances of a PLL featuring a dual control of the voltage-controlled oscillator. [ABSTRACT FROM AUTHOR]

In this work, a methodology for the design of MOS current-mode logic frequency dividers is presented. A mix of hand calculations and circuit simulations is used to relate the power consumption and the frequency of operation. Each latch in the dividers is sized separately in order to minimize the overall power consumption. Furthermore, the effect on the power consumption of circuit parameters such as output swing and voltage gain of the input differential pair is analyzed in detail. The methodology has been applied to dividers by two and dividers by three with 50% output duty cycle. [ABSTRACT FROM AUTHOR]