Search

This article discusses the various operating modes of a series resonant balancing converter for bipolar dc grids. It is shown that the converter can be operated in both the capacitive and inductive regions with respect to the resonant frequency of the LC tank. Furthermore, concerning the pulse width modulation signals to the switches, the converter can either be operated by controlling the phase shift between the converter half bridge legs or the duty cycle of the half bridges. A qualitative comparison of the different modes proves that a) the phase shift modes have better soft switching capabilities, b) the capacitive phase shift mode can show zero voltage switching at switch turn-on in the whole operating range, c) the losses in case of capacitive phase shift mode shows best performance at low load power, d) the inductive region power modes show lower rms current for the same power flow compared with capacitive region modes which lead to lower losses at higher output power. The simulation and experimental results depict the operation of all the modes. Finally, a prototype is designed to validate all operating modes, demonstrating $>$99% system efficiency at 1.75 kW.

In this article, the Linear Time Invariant (LTI) and Linear Time Periodic (LTP) models of two different implementations of the DDSRF-PLL in the presence of voltage imbalance are derived analytically. The accuracy of the models is investigated with time domain simulations, frequency scans, and stability analysis. On top of this, a guideline for properly choosing between LTI and LTP models for stability assessment of the DDSRF-PLL according to the degree of grid voltage imbalance is proposed. Furthermore, it is revealed that, depending on the DDSRF-PLL implementation, the positive-sequence voltage might also cause LTP dynamics, rendering the LTI model inaccurate even when the imbalance is low.

The emphasis on clean and green technologies to curtail greenhouse gas emissions due to fossil fuel-based economies has originated the shift towards electric mobility. As on-road electric vehicles (EVs) have shown exponential growth over the last decade, so have the charging demands. The provision of charging facilities from the low-voltage network will not only increase the distribution system’s complexity and dynamics but will also challenge its operational capabilities, and large-scale upgrades will be required to meet the inevitably increasing charging demands. An ultra-fast (UF) charging infrastructure that replicates the gasoline refueling network is urgently needed to facilitate a seamless transition to EVs and ensure smooth operation. This paper presents a review of state-of-the-art DC fast chargers, the charging infrastructure’s current status, motivation, and challenges for medium-voltage (MV) UF charging stations (UFCS). Furthermore, we consider the possible UFCS architectures and suitable power electronics topologies for UF charging applications. To address the peak formation issues in the daily load profile and high operational expenses of UFCSs, integration of renewable energy sources and energy storage systems due to their technological and economic benefits is being considered. The benefits of line frequency transformer (LFT) replacement with a solid-state transformer (SST), SST models, SST-based UF chargers, and MV SST-based UFCS architectures, as well as related MV active front-end and back-end power electronics topologies, are presented. Finally, the application of microgrids’ hierarchical control architecture is considered for chargers and system-level control and management of UFCSs.