Search

The paper demonstrates deterministic and reliability-based assessment of strength limit states (tensile resistance and pullout) and the service limit state for soil failure for mechanically stabilized earth (MSE) walls constructed with polyester (PET) strap reinforcement. The general approach considers the accuracy of the load and resistance models that appear in each limit state equation plus uncertainty in the estimate of nominal load and resistance values at time of design. Reliability index is computed using a closed-form solution that is easily implemented in a spreadsheet. Three PET strap MSE wall case studies are used to demonstrate the reliability-based assessment approach and to compare margins of safety using different load and resistance model combinations. In some walls using the Coherent Gravity Method to compute loads, the recommended nominal factors of safety for tensile strength and pullout limit states were not satisfied. However, reliability analyses showed that the walls satisfy recommended minimum target reliability index values for the limit states investigated, usually by large amounts. The most critical limit state is the soil failure limit state which is used in the Simplified Stiffness Method to keep the reinforced soil zone at working stress conditions assumed for geosynthetic MSE walls under operational conditions. • Describes deterministic and reliability-based analyses of internal limit states for PET strap walls. • Reliability index is computed using a closed-form solution that is easily implemented in a spreadsheet. • Three PET strap MSE wall case studies are used to demonstrate the reliability-based assessment approach. • Most critical limit state is the soil failure limit state which is used in the Simplified Stiffness Method. • General approach is applicable to MSE walls with extensible and inextensible reinforcement materials. [ABSTRACT FROM AUTHOR]

The paper reports the details of numerical models used to predict the performance of two 3.6 m-high well-instrumented wrapped-face walls. The walls were nominally identical except that the reinforcement material in one wall was a steel welded wire mesh and in the other a biaxial polypropylene geogrid. The backfill soil was modelled using both linear and nonlinear elastic-plastic constitutive models. A general hyperbolic (nonlinear) axial load-strain-time model was used for the reinforcement. The numerical results show good agreement with measured performance features for the welded wire mesh wrapped-face wall. Agreement between numerical predictions of facing displacements and maximum reinforcement loads was less accurate for the very flexible geogrid wrapped-face wall. The discrepancies are believed to be related to the unusually flexible wrapped face used in the geogrid wall construction. Numerically predicted and measured maximum reinforcement loads are compared to loads using the AASHTO reinforcement strength-based design approach (Simplified Method) and the Simplified Stiffness Method which is an empirical reinforcement stiffness-based method. The paper provides physical test data that can be used to benchmark other numerical models, highlights lessons learned during the development of the models, and identifies reasonable expectations for numerical model accuracy for models of similar complexity used to simulate the performance of mechanically stabilized earth (MSE) wall structures under operational conditions. [ABSTRACT FROM AUTHOR]