Search

Taiwan Chelungpu-fault Drilling Project (TCDP) was initiated to understand the physical mechanisms involved in the large displacements of the 1999 Taiwan Chi-Chi earthquake. Continuous measurements of cores (including laboratory work) and a suite of geophysical downhole logs, including P- and S-wave sonic velocity, gamma ray, electrical resistivity, density, temperature, electrical borehole images and dipole-shear sonic imager, were acquired in Hole-A over the depth of 500–2003 m. Integrated studies of cores and logs facilitate qualitative and quantitative comparison of subsurface structures and physical properties of rocks. A total of 10 subunits were divided on the basis of geophysical characteristics. Generally, formation velocity and temperature increase with depth as a result of the overburden and thermal gradient, respectively. Gamma ray, resistivity, formation density, shear velocity anisotropy and density-derived porosity are primarily dependent on the lithology. Zones with changes of percentage of shear wave anisotropy and the fast shear polarization azimuth deduced from Dipole Shear-Imager (DSI) are associated with the appearance of fractures, steep bedding and shear zones. The fast shear wave azimuth is in good agreement with overall dip of the bedding (approximately 30° towards SE) and maximum horizontal compressional direction, particularly in the Kueichulin Formation showing strong shear wave velocity anisotropy. Bedding-parallel fractures are prevalent within cores, whereas minor sets of high-angle, NNW–SSE trending with N- and S-dipping fractures are sporadically distributed. The fault zone at depth 1111 m (FZA1111) is the Chi-Chi earthquake slip zone and could be a fluid conduit after the earthquake. The drastic change in fast shear wave polarization direction across the underlying, non-active Sanyi thrust at depth 1710 m reflects changes in stratigraphy, physical properties and structural geometry. [ABSTRACT FROM AUTHOR]

A moderate earthquake of occurred on 2003 December 10. It ruptured the Chihshang Fault in eastern Taiwan which is the most active segment of the Longitudinal fault as a plate suture fault between the Luzon arc of the Philippine Sea plate and the Eurasian plate. The largest coseismic displacements were 13 cm (horizontal) and 26 cm (vertical). We analyse 40 strong motion and 91 GPS data to model the fault geometry and coseismic dislocations. The most realistic shape of the Chihshang fault surface is listric in type. The dipping angle of the seismic zone is steep (about 60°–70°) at depths shallower than 10 km and then gradually decreases to 40°–50° at depths of 20–30 km. Thus the polygonal elements in Poly3D are well suited for modelling complex surfaces with curving boundaries. Using the strong motion data, the displacement reaches 1.2 m dip-slip on the Chihshang Fault and decreases to 0.1 m near surface. The slip averages 0.34 m, releasing a scalar moment of 1.6E26 dyne-cm. For GPS data, our model reveals that the maximal dislocation is 1.8 m dip-slip. The dislocations decrease to 0.1 m near the surface. The average slip is 0.48 m, giving a scalar moment of 2.2E26 dyne-cm. Regarding post-seismic deformation, a displacements of 0.5 m were observed near the Chihshang Fault, indicating the strain had not been totally released, as a probable result of near-surface locking of the fault zone. [ABSTRACT FROM AUTHOR]