Search

Abstract: Gasification of biomass using high-temperature agents (air/steam) has been proven to have many features superior to those of conventional gasification using low-temperature agents. In this work, an experimental fixed-bed gasifier is utilized to investigate the gasification of biomass using high-temperature air up to 1473 K. A mathematical model has been formulated for the prediction of the main chemical and physical processes and is used to study the influence of temperature, oxygen concentration and flow rate of the feed gas. Predicted gas species concentration profiles and their maximum values are in reasonable agreements with the measurements. The results show that: (a) When the temperature of feed gas is increased, a higher gasification rate, a higher ignition front rate, and higher molar fractions of fuel gases (CO, H2 and C m H n ), thus a higher LHV are obtained. (b) Increased oxygen concentration leads to higher peak values of the fuel gas concentrations, a higher gasification rate, and a larger ignition front rate. (c) Based on the air temperature, two distinct ignition modes are identified: the reaction-controlled and convective-controlled modes. (d) A critical air temperature exists, above which further preheating is no longer efficient if the purpose is to maximise the yield of gaseous products. [Copyright &y& Elsevier]

Abstract: Plasma gasification melting (PGM) is a promising gasification technology aiming at providing sustainable disposal for various wastes. In this work, an Euler–Euler multiphase model was developed to study the characteristics of air and steam gasification of municipal solid waste in a PGM reactor. The model is validated by measurement data from a demonstration PGM reactor. With this model, three groups of simulations were performed to study the influences of operating conditions. It is confirmed that injection of high temperature steam is important for increasing the cold gas efficiency and syngas lower-heating-value. The effect of steam injection is affected by steam feeding rate, air feeding rate and plasma power. Based on the simulated results, an optimal condition is suggested for air and steam gasification in the PGM reactor. [Copyright &y& Elsevier]

Primary fragmentation during rapid pyrolysis is considered to be the critical size reduction mechanism as it determines the particle size distribution and char conversion rates in the fixed bed gasifier. This study aims to investigate the primary fragmentation behavior of Refuse Derived Fuel (RDF) pellets during a rapid pyrolysis process. RDF pellets consisted of different blending ratios of cardboard and polyethylene (PE) were produced by a single-pellet densification process. Pyrolysis tests at temperature ranges of 500–700 °C were performed for each pellet type, and the number and particle size of the fragmented particles were analyzed. The results demonstrate that the different composition of RDF causes different particle binding mechanisms that behave differently during pyrolysis. Densification of cardboard particles can maintain the structure of the pellet char at higher temperatures compared to PE, due to the more stable lignin binding mechanism. A modified Fragmentation Ratio (FR) is introduced to quantify the degree of fragmentation. It is shown that a raise of the concentration of PE from 25 to 75 wt% increases the FR value by up to 4.2 times, whereas an increase in pyrolysis temperature from 500 to 700 °C only slightly changes the FR values. It can be concluded that the type of materials in the RDF pellet has a more dominating effect on the fragmentation compared to the pyrolysis temperature. Further, the volatile matter content of pellets shows a linear correlation with the FR value, whereas no clear relation is found in the case of the pellet's mechanical strength. • Fragmentation RDF pellets were examined during pyrolysis tests at 500–700 °C. • Effects of pyrolysis temperature and pellet compositions were investigated. • Pellets with high cardboard and low plastic contents are less fragmented. • Volatile matter content of pellets shows a linear relation with the fragmentation degree. [ABSTRACT FROM AUTHOR]