Search

Extrusion can lead to an expanded product or to a slightly expanded pellet, known as a third-generation (3G) snack. In this case, expansion occurs subsequently, in an independent thermal device (e.g., oven), out of the extruded pellet. During both processes, several structural changes occur which are linked to processing conditions, including cooking temperature, screw speed, formulation, and initial moisture content. However, a clear relationship between processing variables and the structure of pellets and expanded products has not yet been identified. Accordingly, this work aimed to study the effect of extrusion temperature (110, 135, and 150 °C) and moisture content (27, 29, and 31%) in rice-flour pellets and their microwave expansion, through a microstructural approach using micro-CT. The results showed that the lowest moisture content (27%) and the highest extrusion temperature (150 °C) led to the highest pellet volume and the highest wall thickness, which in turn led to the highest expansion after microwave heating (50 s, 800 W). Interestingly, no significant differences were observed when analyzing the ratio between the volume of the expanded products and the volume of the pellet (~2.4) when using the different processing conditions.

Wheat bran incorporation into biscuits may increase their nutritional value, however, it may affect dough rheology and baking performance, due to the effect of bran particles on dough structure and an increase in water absorption. This study analyzed the enrichment effect of wheat bran and arabinoxylans, the most important non-starch polysaccharides found in whole wheat flour, on dough rheology and thermal behaviour during processing of rotary-moulded biscuits. The objective was to understand the contribution of arabinoxylans during biscuit-making and their impact when incorporated as wheat bran. Refined flour was replaced at 25, 50, 75, or 100% by whole flour with different bran particle sizes (fine: 4% > 500 μm; coarse: 72% > 500 μm). The isolated effect of arabinoxylans was examined by preparing model flours, where refined flour was enriched with water-extractable and water-unextractable arabinoxylans. Wheat bran had the greatest impact on dough firmness and arabinoxylans had the greatest impact on the elastic response. The degree of starch gelatinization increased from 24 to 36% in biscuits enriched with arabinoxylans or whole flour and coarse bran. The microstructural analysis (SEM, micro-CT) suggested that fibre micropores may retain water inside their capillaries which can be released in a controlled manner during baking.

Scant attention has been given to understanding the impact of creaming stability on the final structure of semi-sweet biscuits, an aspect that has traditionally concerned the biscuit industry. Accordingly, the aim of this study was to analyze the influence of the creaming phase stability on the quality attributes of rotary-molded biscuits. Doughs were formulated with 10.2% of fat (wet basis) and 16.3% of sucrose (w.b.), using two sucrose particle sizes, which were either added directly or after dilution in water at different concentrations. Additionally, the creaming phase was prepared using either a low-shear or a high-shear mixer. The results show that an aqueous-phase migration occurred when the creaming was blended in a low-shear mixer, when using either powdered sucrose or granular sucrose diluted in water at a high concentration. The phase separation was inhibited with the high-shear mixer, which provided a stable creaming. Notwithstanding the variation in creaming stability, no differences were observed in hardness, aeration, sweetness, color and noise intensity. Additionally, the micro-CT analysis revealed that biscuits had a similar microstructure (air porosity and thickness of biscuit walls) when they were prepared with either an unstable or a stable creaming phase. Consequently, creaming stability does not seem to affect the structure and the most relevant sensory attributes of rotary-molded biscuits under this set of experimental conditions, which are representative of those used by the industry for this product category.