Search

The migration of melamine and formaldehyde, monomers used in the production of melamine-ware food contact articles, has been determined from 50 retail articles purchased in the UK. The food simulant 3% aqueous acetic acid was used as this is the most aggressive simulant towards melamine plastics. The test conditions used were repeated exposure to the simulant for 2 hours at 70°C, since the articles were all intended for general use including contact with hot foods and beverages. Melamine migrated from 43 of the 50 samples tested and formaldehyde migrated from all 50 samples. Directive 2002/72/EC specifies migration limits for both of these monomers in foods and food simulants. Melamine is restricted by a specific migration limit (SML) of 30 mg/kg (equivalent to 5 mg/dm2) and formaldehyde, along with hexamethylenetetramine expressed as formaldehyde, is restricted by a total (T) SML(T) of 15 mg/kg (equivalent to 2.5 mg/dm2). In all cases the migration of melamine was much lower than the SML for this monomer. The migration of formaldehyde exceeded the SML(T) for 5 of the 50 samples tested. The failure to comply with the SML(T) was accompanied by a number of visible surface effects including discolouration and/or pitting of the simulant contact surface and cracking of the articles. Similar surface effects were observed when one of the samples was exposed to fruit juice which confirmed the suitability of the exposure conditions and 3% acetic acid as a simulant for the articles tested. The ratio of specific migration to overall migration was consistent with, but did not prove, the hypothesis that high formaldehyde migration could be due to the use of excessive hexamethylenetetramine in the polymer formulation. All illegal products were voluntarily removed from the market by the product suppliers.

An analytical method for the determination of the nylon-6 monomer caprolactam in foods is described. The foodstuff was extracted with ethanol : water (1:2) containing capryllactam as internal standard and the extract was defatted using hexane. The extract was analysed by liquid chromatography coupled with mass spectrometry. The test method was calibrated down to 0.7 mg kg−1. The repeatability of the method was good, with a relative standard deviation of 9% at the 15 mg kg−1level. The method was demonstrated to be accurate in an independent external check sample exercise. The new method was applied to the analysis of 50 retail foodstuffs packaged in nylon-6. Caprolactam was detected and confirmed in nine of the 50 food samples, in the range 2.8–13 mg kg−1. The presence of caprolactam was indicated in a further 15 samples, in the range 0.8–11 mg kg−1, but these samples did not meet all of the five confirmation criteria applied. All migration levels (both confirmed and unconfirmed) were below the European specific migration limit for caprolactam, which is 15 mg kg−1. The average migration for all 50 samples, setting non-detectables at half the limit of detection, was 2.6 mg kg−1with a standard deviation of 3.1 mg kg−1(n = 50). All samples found to contain detectable levels of caprolactam migration were for applications involving heating the food in the packaging. They were packs of, for example, sausage meat for which the food would have been heat processed in the nylon casing, or they were nylon pouches for heating foods by boiling, microwaving or roasting.

We report here the first confirmation of the recent Swedish findings of acrylamide in heated foods. The verification exercise used an LC-MS/MS method developed for the purpose as well as an established GCMS method for acrylamide analysis. LC-MS/MS was suitable for the direct determination of acrylamide in aqueous extracts of foods by isotope dilution mass spectrometry (IDMS) using triply deuterated acrylamide. Some food matrices were not suited to the new method and mixed-mode solid-phase extraction (SPE) was used to clean these extracts. The foods tested included UK versions of some of the key food groups analysed in Sweden. Also tested were some foods heated under home-cooking conditions. There was good agreement between the LC-MS/MS results and the GC-MS results and the levels of acrylamide found here were similar to those reported for the corresponding foods analysed in the Swedish study. The analyses confirmed that acrylamide is absent from the raw or boiled foods but present at significant levels in fried, grilled, baked and toasted foods. The highest result was 12000 μg kg-1 acrylamide in overcooked oil-fried chips.