Search

Abstract: Three Itraconazole (ITZ) dry powders for inhalation (DPI) were prepared by spray-drying a mannitol solution in which the ITZ was in suspension (F1) or was in solution without (F2) or with phospholipid (PL) (F3). These powders were endotracheally insufflated in vivo at a single dose of 0.5mg/kg for pharmacokinetic profile (lung and plasma concentration) determination in ICR CD-1 mice. ITZ was crystalline in F1 and assumed to be amorphous in the F2 and F3 formulations. F2 and F3 formulations allowed the in vitro formation of an ITZ supersaturated solution with a maximum solubility of 450±124ng/ml (F2) and 498±44ng/ml (F3), in contrast to formulation F1 (<10ng/ml). As a result of these higher solubilities, absorption into the systemic compartment after endotracheal administration was faster for formulations F2 and F3 (shorter t max) and in larger quantities compared to the F1 formulation (plasmatic AUC0–24h of 182ngh/ml, 491.5ngh/ml and 376.8ngh/ml, and t max of 60min, 30min and 5min for F1, F2 and F3, respectively). PL increased the systemic bioavailability of ITZ (determined by the AUCplasma to AUClung ratio) as a consequence of their wetting and absorption enhancement effect. ITZ lung concentrations after pulmonary administration remained higher than the targeted dose, based on the minimal inhibitory concentrations for Aspergillus fumigatus (2μg/glung), 24h post-administration for both F1 and F2 formulations. However, this was not the case for formulation F3, which exhibited a faster elimination rate from the lung, with an elimination half-life of 4.1h vs. 6.5h and 14.7h for F1 and F2, respectively. [Copyright &y& Elsevier]

Abstract: The aim of this study was to evaluate the ability of the Penn-Century Dry Powder Insufflator for mice (DP-4M®) to reproducibly, uniformly, and deeply deliver dry powders for inhalation in the mouse lung. Itraconazole-based dry powder formulations produced by spray-drying were different in terms of composition (different ratios of drug and mannitol, with or without phospholipids), but relatively similar in terms of particle size and mass median aerodynamic diameter. The ability of the dry powder insufflator to disaggregate each formulation was the same, indicated by the absence of a statistically significant difference between the particle size distribution parameters, as measured by laser scattering. The emitted fraction varied in vivo compared to the in vitro condition. Fluorescent particle distribution in the lungs was uniform and reached the alveolar spaces, as visualized by fluorescent microscopy. In terms of drug recovery in lung tissue, a minimum administered powder mass (in this case ∼1mg) was necessary to recover at least 30% of the emitted dose in the lung and to obtain reproducible pulmonary concentrations. To reduce the dose administered in the lung, it was preferable to dilute the active ingredient within the carrier instead of reducing the dry powder mass inserted in the sampling chamber. Dry powder insufflators are devices usable in dose-dependent preclinical trials but have critical parameters to efficiently deliver reproducible doses depending on the type of formulation. [Copyright &y& Elsevier]