Search

The effects of the fuel injection pressure on a heavy-duty diesel engine exhaust particle emissions were studied. Nonvolatile particle size distributions and gaseous emissions were measured at steady-state engine conditions while the fuel injection pressure was changed. An increase in the injection pressure resulted in an increase in the nonvolatile nucleation mode (core) emission at medium and at high loads. At low loads, the core was not detected. Simultaneously, a decrease in soot mode number concentration and size and an increase in the soot mode distribution width were detected at all loads. Interestingly, the emission of the core was independent of the soot mode concentration at load conditions below 50%. Depending on engine load conditions, growth of the geometric mean diameter of the core mode was also detected with increasing injection pressure. The core mode emission and also the size of the mode increased with increasing NOx emission while the soot mode size and emission decreased simultaneously.

Heavy duty diesel engine exhaust characteristics were studied with direct tailpipe sampling on an engine dynamometer. The exhaust particle size distributions, total particle mass, and gaseous emissions were measured with different load conditions without after-treatment. The measured particle size distributions were bimodal; distinctive accumulation and nucleation modes were detected for both volatile and dry particle samples. The condensing volatile compounds changed the characteristics of the nonvolatile nucleation mode while the soot/accumulation mode characteristics (concentration and diameter) were unchanged. A clear dependence between the soot and the nonvolatile nucleation mode number concentrations was detected. While the concentration of the soot mode decreased, the nonvolatile nucleation mode concentration increased. The soot mode number concentration decrease was related to soot-NOx trade-off; the decrease of the exhaust gas recirculation rate decreased soot emission and increased NOx emission. Simultaneously detected increase of the nonvolatile nucleation mode concentration may be caused by the decrease of the soot mode sink or by changed combustion characteristics. However, the total particle number concentration increased with decreasing soot mode number concentration. The proportion of the particle number concentration between the nonvolatile nucleation and soot mode followed the NO2:NO ratio linearly. While ratio NO2:NO increased the proportion of soot mode number concentration in total number concentration increased. Regardless of the mechanism that causes the balance between the soot mode and the nonvolatile nucleation mode emissions, the changes in the particle number size distribution should be taken into account while the particle mass emissions are controlled with combustion optimization.