Search

Recent technological advances have made it possible to produce particles with nanometer dimensions that are uniformly and steadily suspended in traditional solar liquids and have enhanced the impact of thermo-physical parameters. In this research, a three-dimensional flat plate solar collector was built using a thin flat plate and a single working fluid pipe. The physical model was solved computationally under conditions of conjugated laminar forced convection in the range 500 ≤ Re ≤ 1900 and a heat flux of 1000W/m². Distilled water (DW) and different types of hybrid nanofluids (namely, 0.1%-Al2O3@Cu/DW, 0.1%-MWCNTs@Fe3O4/DW, 0.3%-MWCNTs@Fe3O4/DW, 0.5%-Ag@MgO/DW, 1%-Ag@MgO/DW, 1%-S1 and 1%-S2, where MWCNTs are multi-wall carbon nanotubes, S1 means 2CuO--1Cu and S2 means 1CuO--2Cu nanocomposites) were evaluated via a set of parameters. The numerical results revealed that, by increasing the working fluid velocity (the Reynolds number), the average heat transfer coefficient, pressure loss, heat gain and solar collector efficiency were increased. Meanwhile, outlet fluid temperature and flat plate surface temperature were decreased. At Re = 1900, 1%-S2 and 1%-S1 presented higher thermal performance enhancement by 44.28% and 36.72% relative to DW. Moreover, low thermal performance enhancement of 7.59% and 7.44% were reported by 0.1%-Al2O3@Cu/DW and 0.3%-MWCNTs@Fe3O4/DW, respectively. [ABSTRACT FROM AUTHOR]

The flat-plate solar collector (FPSC) three-dimensional (3D) model was used to numerically evaluate the energy and economic estimates. A laminar flow with 500 ≤ Re ≤ 1900, an inlet temperature of 293 K, and a solar flux of 1000W/m² were assumed the operating conditions. Two mono nanofluids, CuO-DW and Cu-DW, were tested with different shapes (Spherical, Cylindrical, Platelets, and Blades) and different volume fractions. Additionally, hybrid nanocomposites from CuO@Cu/DW with different shapes (Spherical, Cylindrical, Platelets and Blades), different mixing ratios (60%+40%, 50%+50% and 40%+60%) and different volume fractions (1 volume%, 2 volume%, 3 volume% and 4 volume%) were compared with mono nanofluids. At 1 volume% and Re = 1900, CuO-Platelets demonstrated the highest pressure drop (33.312 Pa). CuO-Platelets achieved the higher thermal enhancement with (8.761%) at 1 vol.% and Re = 1900. CuO-Platelets reduced the size of the solar collector by 25.60%. Meanwhile, CuO@Cu-Spherical (40:60) needed a larger collector size with 16.69% at 4 vol.% and Re = 1900. CuO-Platelets with 967.61, CuO -- Cylindrical with 976.76, Cu Platelets with 983.84, and Cu-Cylindrical with 992.92 presented the lowest total cost. Meanwhile, the total cost of CuO -- Cu -- Platelets with 60:40, 50:50, and 40:60 was 994.82, 996.18, and 997.70, respectively. [ABSTRACT FROM AUTHOR]