Search

This research was carried out to compare selected forecasting methods, such as the following: Artificial Neural Networks (ANNs), Classification and Regression Trees (CARTs), Chi-squared Automatic Interaction Detector (CHAID), Fuzzy Logic Toolbox (FUZZY), Multivariant Adaptive Regression Splines (MARSs), Regression Trees (RTs), Rough Set Theory (RST), and Support Regression Trees (SRTs), in the context of determining the temperature of brine from vertical ground heat exchangers used by a heat pump heating system. The subject of the analysis was a public building located in Poland, in a temperate continental climate zone. The results of this study indicate that the models based on Rough Set Theory (RST) and Artificial Neural Networks (ANNs) achieved the highest accuracy in predicting brine temperature, with the choice of the preferred method depending on the input variables used for modeling. Using three independent variables (mean outdoor air temperature, month of the heating season, mean solar irradiance), Rough Set Theory (RST) was one of the best models, for which the evaluation rates were as follows: CV RMSE 21.6%, MAE 0.3 °C, MAPE 14.3%, MBE 3.1%, and R2 0.96. By including an additional variable (brine flow rate), Artificial Neural Networks (ANNs) achieved the most accurate predictions. They had the following evaluation rates: CV RMSE 4.6%, MAE 0.05 °C, MAPE 1.7%, MBE 0.4%, and R2 0.99. [ABSTRACT FROM AUTHOR]

The article presents the results of research on the range of the impact of a cooling facility on the surrounding ground. An analysis of the heat exchange with the ground and through the building partitions was carried out. The analysis was carried out on the basis of the results of actual field tests carried out throughout the measurement year. The object of the research was an agricultural cold store located in southern Poland. The computational analysis of the interaction between the cooling facility and the ground was based on the numerical elementary balances method. The validation of the calculation model was performed based on the adopted boundary conditions. Calculations for the analyzed variants were carried out on the basis of a geometric model of the cooling facility built in the WUFI®plus program, corresponding to the actual dimensions. The analysis of the energy balance of the studied facility showed that the share of energy flow through the floor to the ground constitutes 8.2% of all energy flows through other partitions and the ventilation system. In order to maintain the set air temperature inside the studied building, intensive cooling was required with an energy demand of 5184.5 kWh/year. The results of the research showed that the range of the thermal impact of the building changes depending on the location of the studied ground area in terms of cardinal direction. The external and internal microclimate characteristics also affect the extent of the impact of the cooling facility on the surrounding ground. Under the assumption of stable values of Θi within a range of 0.0–4.0 °C, the largest range of influence (4.0 m) occurs in the summer. [ABSTRACT FROM AUTHOR]

Natural smoke control systems in staircases are one of the available systems used for the protection of escape routes from smoke and are one of the most utilised for medium to high rise buildings. However, their effectiveness (as well as other ventilation systems) is strongly dependent on the weather conditions, especially the outdoor temperature. This paper describes the results of real-scale experiments of the airflow in a staircase's natural smoke exhaust system. The experimental staircase was localised in a medium-high building, "LabFactor" at the Lodz University of Technology in Poland. The experiments were performed over a period of six months, from February to July 2019, and included measurements of external and internal air temperature as well as the airflow through the staircase. The results obtained enabled an evaluation of the effectiveness of the ventilation and natural smoke exhaust system in the staircase, in relation to external temperatures. It was found that natural smoke exhaust systems could operate below an acceptable level of effectiveness for nearly 25% of the year. The experimental results were confirmed with CFD simulations. [ABSTRACT FROM AUTHOR]

This article presents the influence of climatic conditions on surface water quality. The research methodology, including physicochemical analysis from the Gołdapa and Bludzia rivers, is presented. The research lasted for two years. The results of the physicochemical studies of the Gołdapa and Bludzia rivers in early spring, spring, and autumn show that each of these seasons impacts the quality of surface waters. Moreover, it was proven that all the parameters are strongly correlated with the air temperature, the sum of daily precipitation, and water levels. For detailed analysis, the obtained results of own research were compared with meteorological and hydrological data from the last 15 years (2005–2021) for the region of north-eastern Poland. It was proven that temperature changes contribute to increased surface water pollution in the north-eastern part of Poland. Waters from areas that humans have not developed are of better quality than those that drain the urban area, which is reflected in the case of the superior quality of the Bludzia river compared to the Gołdapa river. The upward trend in temperature in the Gołdap region indicates that global warming will continue. [ABSTRACT FROM AUTHOR]

Modern buildings with new heating, ventilation and air conditioning (HVAC) systems offer possibility to fit parameters of the indoor environment to the occupants' requirements. The present paper describes the results of measurements performed in an office room in the first Polish passive commercial office building during four months of normal operation. They were used to calculate parameters describing thermal comfort: vertical air temperature profile, floor surface temperature, predicted mean vote (PMV) and predicted percent of dissatisfied (PPD). Obtained results confirmed good thermal conditions in the analysed room. The average temperature of the floor's surface varied from 20.6 °C to 26.2 °C. The average vertical air temperature, calculated for working days, was from 22.5 °C to 23.1 °C. The temperature difference between the floor and 5 cm below the ceiling was from −0.9 °C to 6.3 °C. The PMV index varied from 0.52 to 1.50 indicating 'slightly warm' sensation, in spite of 'neutral' reported by employees. Also measured cooling and heating energy consumption was presented. The performed measurements confirmed the ability of thermally activated building system (TABS) to keep good thermal conditions. [ABSTRACT FROM AUTHOR]

The paper deals with the impact of the technological break duration during the cold storage cycle on the energy demand of the cold store for vegetables and fruit and the temperature distribution in the ground under the cold store. The studied facility was a two-chamber vegetable cold store located in southern Poland used to store carrots (Daucus carota) for nine months a year. The experiments were conducted for 12 months (01.05.2017–30.04.2018). The technological break during this period lasted three months (from 1 July 2018 to 30 September 2018). Continuous measurements (with 1-h frequency) were made in order to determine the boundary conditions for numerical analysis. The measured parameters included indoor air temperature, outdoor air temperature, ground temperature under the building and in its vicinity. There were 22 measuring points andPT100 sensors were used. The numerical analysis was based on the elementary balances method. WUFIplus® software was used as a calculation supporting tool. The numerical analysis was conducted for 14 calculation variants, with different duration of technological break. The calculation model validation was performed and the results showed a good correlation with the experimental data. The results of experimental studies and of calculations showed a significant impact of the technological break duration on the soil distribution in the ground and the building energy demand. A technological break of less than 4 weeks is the most optimal in the summer. The technological break longer than 4 weeks significantly affects the cooling energy demand in the first days of the cooling cycle and significantly extends the time necessary for the ground and the floor to reach the optimum temperature. The analysis of the floor temperature results (points A1–C1) showed that the technological break longer than four weeks causes the average floor temperature to exceed 4.0 °C. Therefore, the optimum solution is technological break lasting 7–35 days. Absence of technological break results in a decrease of energy gains from the ground by 20% relative to a three-month technological break. The impact of technological break duration was clearly seen in terms of energy losses from the cold store to the ground. In case of a 91-day technological break, the energy losses to the ground were 1289.5 kWh/a, while in case of absence of technological break this value was ninefold lower (147.5 kWh/a). [ABSTRACT FROM AUTHOR]

The article analyzes a ground-to-air heat exchanger (GAHE) for a mechanical ventilation system in a building. The heat exchanger's performance was evaluated in northeastern Poland between May and August of 2016, 2017, and 2018. In spring and summer, the GAHE can be theoretically used to precool air for HVAC systems. The aim of the study was to compare the real-world performance of GAHE with its theoretical performance determined based on the distribution of ground temperature and the temperature at the GAHE outlet modeled in compliance with Standard PN-EN 16798-5 1:2017-07. The modeled values differed considerably from real-world data in May and June, but the model demonstrated satisfactory data fit in July and August. In all years, the modeled average monthly air temperature at the GAHE outlet was 8.3 °C below real-world values in May, but the above difference was only 1.1 °C in August. The developed mathematical model is simple and easy to use, and it can be deployed already in the preliminary design stage. It does not require expensive software or expert skills. However, this study revealed that the model has several limitations. The observed discrepancies should be taken into account when modeling the performance of a GAHE. [ABSTRACT FROM AUTHOR]

The thermal sensations of people differ from each other, even if they are in the same thermal conditions. The research was carried out in a didactic teaching room located in the building of the Faculty of Civil and Environmental Engineering in Poland. Tests on the temperature were carried out simultaneously with questionnaire surveys. The purpose of the survey was to define sensations regarding the thermal comfort of people in the same room, in different conditions of internal and external temperatures. In total 333 questionnaires were analyzed. After the discriminant and neural analyses it was found that it is not possible to forecast the thermal comfort assessment in the room based on the analyzed variables: gender, indoor air temperature, external wall radiant temperature, and outdoor air temperature. The thermal comfort assessments of men and women were similar and overlapped. The results of this study confirm that under the same thermal conditions about 85% of respondents assess thermal comfort as good, and about 15% of respondents assess thermal comfort as bad. The test results presented in this article are similar to the results of tests carried out by other authors in other climatic conditions. [ABSTRACT FROM AUTHOR]

Works of art are sensitive to environmental factors—mainly temperature and relative humidity—which, when stable, are generally recommended as ideal protection conditions, but in historical museum buildings, the required conditions are difficult to maintain, due to a lack of adequate heating, ventilation and air-conditioning systems. The paper presents the analysis of one-year measurements of temperature and relative humidity in three different museums in Poland. The aim of the research was to identify the risk to museum collections, due to unbalanced moisture loads and unstable indoor air temperatures, as well as to identify possible causes of fluctuations in these parameters. This article focuses on assessing the impact of variable external and internal loads on the hygrothermal parameters of indoor air. The profile of internal hygrothermal loads in exhibition halls varied over time, which resulted in a temporary variation of the indoor environmental parameters. The lack of appropriate systems, shaping the microclimate in the analyzed museums, and the lack of automatic control in existing devices did not allow to maintain the temperature and relative humidity within appropriate limits. In the museums, the maximum indoor temperature values were higher than those recommended in the requirements. Relative humidity values in all museums exceeded the recommended range both above and below. [ABSTRACT FROM AUTHOR]

This paper presents an analysis of thermal interaction between a building and surrounding soil. The examined building was located in southern Poland. Measurements of selected indoor and outdoor air temperature parameters were made in order to determine the boundary conditions. The soil temperature measurements were conducted at 42 points. The analysis of results is divided into four periods: summer, autumn, winter, and spring. The analysis show that weather conditions significantly affect the temperature in soil, but the range of residential building impact decreases with distance, and it varies depending on the season. The residential building impact on the soil temperature is in the range of 1.2–3.3 m. This paper also includes a study of the heat flow direction in soil and a quantitative estimate of heat exchange between a building and the soil. The greatest energy losses 2082 kWh (21.24 kWh/m2) from the building to the soil were recorded in winter. In spring, the energy losses were reduced by about 38% as compared with the energy losses in winter, and the energy losses in spring were comparable to autumn. [ABSTRACT FROM AUTHOR]