Search

Airborne dust and dust storms are natural disasters that transport dust over long distances from the source basin, sometimes reaching hundreds of kilometers. Today, Iraq is a basin that produces dust storms that strike all neighboring countries such as Iran, Kuwait and Saudi Arabia. These storms affect the productivity and capacity of the photovoltaic modules and reduce the amount of electricity that is generated clearly. Airborne dust reduces the intensity of solar radiation by scattering and absorbing it. In addition, the dust accumulated on the photovoltaic modules causes a deterioration in their productivity. In this study, an extensive review of wind movement and its sources, especially those that hit the city of Baghdad, the capital of Iraq, was conducted. Practical experiments were also carried out during a storm to measure important variables that had not been measured practically before at this site. The experimental tests were carried out starting from 1 April 2022 and continued until 12 April. Within this period, a dust storm occurred that lasted for three consecutive days that was considered one of the most severe storms that the city of Baghdad had experienced in the last few years. Practical measurements showed a deterioration in the solar radiation intensity by up to 54.5% compared to previous days. The air temperature during the storm decreased by 21.09% compared to the days before the storm. From the measurements of ultrafine aerosol particles PM1 and PM2.5, there was a significant increase of 569.9% and 441% compared to the days before the storm, respectively. Additionally, the measurements showed an increase of 217.22% and 319.21% in PM10 and total suspended particles, respectively. Indoor performance experiments showed a deterioration of current, voltage, power and electrical efficiency by 32.28%, 14.45%, 38.52% and 65.58%, respectively, due to dust accumulated during the storm days compared to the previous days. In the outdoor experiments, the rates of deterioration of current, voltage, power and electrical efficiency were greater, reaching 60.24%, 30.7%, 62.3% and 82.93%, respectively, during the storm days compared to the days before it. During a storm, cleaning the panels is futile due to the high concentration of dust in the air, especially by water. However, the photovoltaic modules can be dry cleaned with bristle brushes after the storm has subsided. [ABSTRACT FROM AUTHOR]

The Urban Heat Island (UHI) has a detrimental impact on human thermal comfort and the health of city dwellers through raising average temperatures. Urban geometry is one of the factors that affect the intensity of the UHI phenomena. The purpose of this research is to evaluate and compare traditional vs. modern urban forms with respect to temperature and thermal comfort in the United Arab Emirates. Three of each were chosen based on their densities and form. Traditional buildings in the UAE differ from others in the Middle East in that they are primarily single-story, while in the surrounding countries of the region, such as Iran, Iraq, and Saudi Arabia, they are mainly two stories. The UAE climate also has its distinct characteristics. Each configuration was investigated using the ENVI-met urban microclimate simulation software. The comparisons were made for three seasons: summer, winter, and spring. Each configuration was evaluated through four parameters: building shape, street geometry, orientation, and urban density. The results revealed that the low-density traditional urban form exhibited the lowest air temperature in August because it has a low sky view factor (SVF), high height-to-width ratio, and less density. The highest ambient temperature was observed in the sites with low-medium density, lowest height/width ratio, and maximum SVF. The high-density modern urban form displayed lower air temperatures in the summer season than the low and low-medium-density modern urban sites due to the building form, high height-to-width ratio, low SVF, and wind corridors. The traditional compact urban form in Al Fahidi, which has the highest urban density of the six configurations, achieved the best thermal comfort levels in the summer due to the sizable height-to-width ratio and lowest SVF. [ABSTRACT FROM AUTHOR]