Search

To date, microwave radiation has been successfully used to support the chemical hydrolysis of organic substrates in the laboratory. There is a lack of studies on large-scale plants that would provide the basis for a reliable evaluation of this technology. The aim of the research was to determine the effectiveness of using microwave radiation to support the acidic and alkaline thermohydrolysis of lignocellulosic biomass prior to anaerobic digestion on a semi-industrial scale. Regardless of the pretreatment options, similar concentrations of dissolved organic compounds were observed, ranging from 99.0 ± 2.5 g/L to 115.0 ± 3.0 in the case of COD and from 33.9 ± 0.92 g/L to 38.2 ± 1.41 g/L for TOC. However, these values were more than twice as high as the values for the substrate without pretreatment. The degree of solubilisation was similar and ranged between 20 and 28% for both monitored indicators. The highest anaerobic digestion effects, ranging from 99 to 102 LCH4/kgFM, were achieved using a combined process consisting of 20 min of microwave heating, 0.10–0.20 g HCl/gTS dose, and alkaline thermohydrolysis. For the control sample, the value was only 78 LCH4/kgFM; for the other variants, it was between 79 and 94 LCH4/kgFM. The highest net energy gain of 3.51 kWh was achieved in the combined alkaline thermohydrolysis with NaOH doses between 0.10 and 0.20 g/gTS. The use of a prototype at the 5th technology readiness level made it possible to demonstrate that the strong technological effects of the thermohydrolysis process, as demonstrated in laboratory tests to date, do not allow for positive energy balance in most cases. This fact considerably limits the practical application of this type of solution. [ABSTRACT FROM AUTHOR]

Research to date has mainly focused on the properties and efficiency of the production of selected, individual types of biofuels from microalgae biomass. There are not enough studies investigating the efficiency of the production of all energy sources synthesised by these microorganisms in a single technological cycle. The aim of this research was to determine the possibilities and efficiency of the production of hydrogen, bio-oil, and methane in the continuous cycle of processing T. subcordiformis microalgae biomass. This study showed it was feasible to produce these three energy carriers, but the production protocol adopted was not necessarily valuable from the energy gain standpoint. The production of bio-oil was found to be the least viable process, as bio-oil energy value was only 1.3 kWh/MgTS. The most valuable single process for microalgae biomass conversion turned out to be methane fermentation. The highest specific gross energy gain was found after applying a protocol combining biomass production, hydrogen biosynthesis, and subsequent methane production from T. subcordiformis biomass, which yielded a total value of 1891.4 kWh/MgTS. The direct methane fermentation of T. subcordiformis biomass enabled energy production at 1769.8 kWh/MgTS. [ABSTRACT FROM AUTHOR]

Anaerobic wastewater treatment is, in many cases, a justified alternative to typical activated sludge processes, from a technological, economic, and ecological point of view. The optimisation of fermentation reactors is primarily concerned with increasing the biodegradation of organic compounds and biogas production, as well as improving efficiency in the removal of nitrogen and phosphorus compounds. The aim of the research was to determine the impact of using low-cost recycled filling on the efficiency of treating real confectionery wastewater in a vertical anaerobic labyrinth flow bioreactor. The experiments focused on selecting the organic loading rate that would allow for the effective biodegradation and removal of pollutants, as well as the efficient production of biomethane. It was found that the tested reactor can operate efficiently at a maximum organic loading rate (OLR) of 7.0–8.0 g of chemical oxygen demand (COD)/L·d. In this OLR range, high efficiency was guaranteed for both wastewater treatment and biogas production. However, increasing the OLR value to 8.0 g COD/L·d had a significant negative effect on the methane (CH4) content in the biogas. The most efficient variants achieved a biodegradation efficiency of around 90% of the organic compounds, a CH4 content of over 70% in the biogas, and a biogas yield of over 400 L/kg of COD removed. A significant influence of the applied OLR on the ratio of free organic acids (FOS) to total alkaline capacity (TAC) and pH was observed, as well as a strong correlation of these indicators with the specific biogas yield and CH4 content. The application of a solution based on the use of a hybrid system of anaerobic granulated sludge and an anaerobic filter resulted in an efficient treatment process and an almost complete elimination of suspensions from the wastewater. [ABSTRACT FROM AUTHOR]

The characteristics of excess aerobic granular sludge, related to its structure and chemical composition, limit the efficiency of anaerobic digestion. For this reason, pre-treatment methods and compositions with other organic substrates are used. In earlier work, no attempt was made to intensify the methane fermentation of the excess aerobic granular sludge by adding fatty waste materials. The aim of the research was to determine the effects of co-digestion of pre-hydrodynamically cavitated aerobic granular sludge with waste fats on the efficiency of methane fermentation under mesophilic and thermophilic conditions. The addition of waste fats improved the C/N ratio and increased its value to 19. Under mesophilic conditions, the highest effects were observed when the proportion of volatile solids from waste fats was 25%. The amount of biogas produced increased by 17.85% and CH4 by 19.85% compared to the control. The greatest effects were observed in thermophilic anaerobic digestion at 55 °C, where a 15% waste fat content in volatile solids was ensured. This resulted in the production of 1278.2 ± 40.2 mL/gVS biogas and 889.4 ± 29.7 mL/gVS CH4. The CH4 content of the biogas was 69.6 ± 1.3%. The increase in biogas and CH4 yield compared to pure aerobic granular sludge anaerobic digestion was 34.4% and 40.1%, respectively. An increase in the proportion of waste fats in the substrate had no significant effect on the efficiency of methane fermentation. Strong positive correlations (R2 > 0.9) were observed between biogas and CH4 production and the C/N ratio and VS concentration. [ABSTRACT FROM AUTHOR]

The use of aerobic granular sludge is a promising and future-proof solution for wastewater treatment. The implementation of this technology requires the development of efficient and cost-effective methods for the management of excess sludge. The aim of the research was to evaluate the effects of hydrodynamic cavitation on the efficiency of aerobic granular sludge digestion. Respirometric measurements were performed at a temperature of 38 °C and an initial organic load of 5.0 gVS/L. The changes in the properties of the pretreated biomass, the kinetics of methane fermentation, the amount and composition of the biogas produced, and an energetic evaluation of the process were carried out. A significant influence of hydrodynamic cavitation on the transfer of organic compounds into the dissolved phase was demonstrated. The degree of solubilisation was 37% for COD and 42% and for TOC. The efficiency of CH4 production from the pretreated sludge reached a value of 496 ± 12 mL/gVS, which corresponds to an increase of 19.6% compared to the raw biomass. The influence of cavitation on the CH4 content of the biogas was not observed. Strong correlations were found between the efficiency of anaerobic digestion and the concentration of dissolved organic compounds and the hydrodynamic cavitation time used. The gross energy yield was closely correlated with the amount of CH4. The highest comparable values of 3.12 Wh/gTS to 3.18 Wh/gTS were found in the variants in which the hydrodynamic cavitation (HC) time was between 15 min and 50 min. The highest net energy production of 2890 kWh/MgTS was achieved after 15 min of pretreatment. [ABSTRACT FROM AUTHOR]

Anaerobic wastewater treatment is still a dynamically developing technology ensuring the effective degradation of organic compounds and biogas production. As evidenced in the large scale-up, this technological solution surpasses aerobic methods in many aspects. Its advantages stem from the feasibility of operation at a high organic load rate, the smaller production of difficult-to-manage sewage sludge, the smaller space and cubature required, and the high-methane biogas ultimately produced. The exploitation of anaerobic reactors is in line with the assumption of a circular economy, material recycling by reduced CO2 emissions and energy consumption, and the production of renewable energy. Despite their unquestionable advantages, there is still a need to seek novel approaches and improve the currently exploited installations. The key avenues of research entail improvements in the stability of bioreactor operations and the enhancement of bioreactor adaptability to changing and unfavorable process parameters. The versatility of such systems would also be greatly improved by increasing nitrogen and phosphorus removal rates. Attempts have been made to achieve these goals by setting up separate zones within bioreactors for the individual steps of methane fermentation, incorporating active fillings to promote nutrient removal, and introducing chemical and physical treatments. An interesting solution is also the use of microwave radiation to stimulate temperature conditions and induce non-thermal phenomena, such as enhancing the enzymatic activity of methanogenic microflora. Another prospective approach is to integrate digesters into microalgal biomass production systems. The aim of this review paper is to present the thus-far technological knowledge about anaerobic wastewater treatment, including standard solutions and innovative ones, the effectiveness of which has been corroborated in pilot-scale installations. [ABSTRACT FROM AUTHOR]