Search

Construction of the Włocławek Barrage on the Vistula River in 1970 became an important source of energy; however, it discontinued sediment transport in the Vistula River. This phenomenon resulted in accumulation before and erosion below the barrage; a similar problem can be expected due to the planned construction of the Lower Vistula Cascade. This study is dedicated to finding an effective and feasible solution to sediment transport management, acceptable to a wide group of users (e.g., navigation, energy producers, and ecologists). A numerical 1D model was applied to carry out analysis of hydrodynamics and sediment transport in the river section from Włocławek Barrage to the Vistula River mouth in the Baltic Sea. For calibration, historical data describing the accumulation and erosion created by the Włocławek Barrage were used. The proposed model allowed incorporation of new barrages chronologically, in accordance with the proposed time schedules. Analysis was carried out in a 50-year horizon, using a set of historical flow data. For sediment flushing, it was proposed to use natural flooding events exceeding Q10% discharge and to control sediment management of the adjacent barrages. To use this method in practice requires verification. [ABSTRACT FROM AUTHOR]

In order to increase the lifespan of hydraulic turbines in hydropower plants, it is necessary to minimize damages caused by sediment erosion. One solution is to reduce the amount of sediments by improving the design of sand trap. In the present work, the effects on sand trap efficiency by installing v-shaped rake structures for flow distribution and rib structures for sediment trapping is investigated numerically using the SAS–SST turbulence model. The v-shaped rake structures are located in the diffuser near the inlet of the sand trap, while the ribs cover a section of the bed in the downstream end. Three-dimensional models of the sand trap in Tonstad hydropower plant are created. The present study showed that integrating rib type structure can reduce the total weight of sediments escaping the sand trap by 24.5%, which leads to an improved sand trap efficiency. Consequently, the head loss in the sand trap is increased by 1.8%. By additionally including the v-shaped rakes, the total weight of sediments escaping the sand trap is instead increased by 48.5%, thus worsening the sand trap efficiency. This increases head loss by 12.7%. The results also show that turbulent flow commencing at the sand trap diffuser prevents the downstream settling of sediments with a diameter of less than one millimeter. The hydraulic representation of the numerical model is validated by comparison with particle image velocimetry measurements of the flow field from scale experiments and ADCP measurements from the prototype. The tested rib design has not previously been installed in a hydropower plant, and can be recommended. The tested v-shaped rakes have been installed in existing hydropower plants, but this practice should be reconsidered. [ABSTRACT FROM AUTHOR]