Search

Most power transformers are oil-immersed transformers for which its insulation system consists of oil and cellulosic solid. The insulation liquid impregnates the solid-covering air spaces, which improves the efficiency of the insulation system. Not only does the oil ensure electrical insulation but it also works as coolants transferring the heat generated during transformer operation to the exterior of the transformer. Throughout normal operation conditions, transformers experience multiple stresses that degrade their insulation. Since the lifetime of oil-immersed transformers is defined mainly by the state of the insulation paper, it is critical to understand the behavior and degradation mechanisms of new insulation systems that try to overcome the drawbacks of mineral oil as well as to improve power transformer performances. The current increased prevalence of the nonlinear loads additionally stresses power transformers, which generates their premature ageing or even failure. Consequently, new materials and assessment methods are required to guarantee the suitable management of power transformer populations. In this Special Issue "Experimental and Numerical Analysis of Thermal Ageing in Power Transformers", four papers have been published. The guest editor also describes briefly some challenges involved beyond the coverage of this Special Issue. [ABSTRACT FROM AUTHOR]

Managing a large fleet of ageing assets has become a technical challenge faced by many electricity utilities in developed countries. Asset managers are increasingly interested in techniques that can help extend the useful lifetime of a transformer. Oil regeneration is one of such techniques. In this paper, oil regeneration experiments were performed on a 6.4/0.4 kV retired distribution transformer to investigate the effect of oil regeneration on improving paper conditions. Oil regeneration was conducted in two stages, with the first stage aimed at 'cleaning the oil' and the second stage targeted at 'cleaning the paper'. Oil samples were collected at regular intervals throughout the process and paper samples were obtained from the transformer before and after each oil regeneration stage. It was found that oil regeneration restores oil parameters, including moisture and acidity, similar to those of new oils at the end of stage 1. Analysis of paper samples indicated a reduction in paper moisture at the end of stage 2 by nearly 40%, while low molecular weight acids (LMA) in paper exhibited a reduction by around 30% on average. It is found that the extended oil regeneration period, i.e., stage 2, is necessary to improve the paper condition and hence to reduce the paper ageing rate. [ABSTRACT FROM AUTHOR]