Search

Southern Africa has a huge potential for renewable energy sources such as hydro, solar, wind, biomass, and geothermal. However, electricity access remains a key policy issue for most member states, with a global average access to electricity of only 54% in 2019. This low electrification rate is a strong motivation for member states to increase renewable energy use and improve access to electricity for all. The goal of this paper was to present a literature review of methodologies, energy plans, and government programs that have been implemented by the Southern African Development Community member states to address the region's low average electrification rate and greenhouse gas emission reduction targets. The study presents the most commonly used methodologies for the integration of renewable energies into electrical systems, considering the main grid and distributed generation systems. LCOE minimization methodologies and software options, such as GIS, HOMER, LEAP, and EnergyPLAN, are the most common among the identified studies. The traditional method of electrifying by expanding the grid has not contributed to the eradication of energy poverty in rural areas. Therefore, to improve electricity access in Southern Africa, it is essential to consider off-grid solutions based on renewable energy sources. [ABSTRACT FROM AUTHOR]

Renewable Distributed Generation (RDG), when connected to a Distribution Network (DN), suffers from power quality issues because of the distorted currents drawn from the loads connected to the network over generation of active power injection at the Point of Common Coupling (PCC). This research paper presents the voltage rise regulation strategy at the PCC to enhance power quality and continuous operation of RDG, such as Photovoltaic Arrays (PVAs) connected to a DN. If the PCC voltage is not regulated, the penetration levels of the renewable energy integration to a DN will be limited or may be ultimately disconnected in the case of a voltage rise issue. The network is maintained in both unity power factor and voltage regulation mode, depending on the condition of the voltage fluctuation occurrences at the PCC. The research investigation shows that variation in the consumer's loads (reduction) causes an increase in the power generated from the PVA, resulting in an increase in the grid current amplitude, reduction in the voltage of the feeder impedance and an increase in the phase voltage amplitude at the PCC. When the system is undergoing unity power factor mode, PCC voltage amplitude tends to rises with the loads. Its phase voltage amplitude rises above an acceptable range with no-loads which are not in agreement, as specified in the IEEE-1547 and Southern Africa grid code prerequisite. Incremental Conduction with Integral Regulator bases (IC + PI) are employed to access and regulate PVA generation, while the unwanted grid current distortions are attenuated from the network using an in-loop second order integral filtering circuit algorithm. Hence, the voltage rise at the PCC is mitigated through the generation of positive reactive power to the grid from the Distribution Static Compensator (DSTATCOM), thereby regulating the phase voltage. The simulation study is carried out in a MATLAB/Simulink environment for PVA performance. [ABSTRACT FROM AUTHOR]