Search

The work consists of the development of a market-friendly 600 W photovoltaic battery-less water pumping system. The system is composed of four 280 Wp solar panels, an auxiliary 10 W solar panel, a three-phase converter and a ½ horsepower (hp) submersible water pump. The electronic stage involves a resonant DC-DC converter in series with a voltage source three-phase inverter. The novelties of this work are related to the use of a resonant DC-DC converter with fixed duty-cycle and frequency for water pumping application, the use of Silicon Carbide Metal-Oxide-Semiconductor Field-Effect Transistors (MOSFETs) for solving converter startup issues, and the use of a constant voltage maximum power tracking (MPPT) algorithm with auxiliary panels. The work displays the design of the converter, simulation and experimental results, discussions, and cost evaluation. The feasibility of the system is studied for the water requirements of a beef cattle farm in Brazil.

This paper describes the use of a Cascaded H-Bridge Multilevel Inverter to deal with the problem of partial shading in a photovoltaic system connected to the grid. Combined with the topology, it proposes the use of a virtual synchronous generator for power sharing between photovoltaic arrays and to ensure the connection to the power grid even in extreme shading situations with no power buffer. The experimental results demonstrate the feasibility of the strategy adopted and the limitations to overcome.

This work compares the performance of two embedded FPGA controllers that can be used in Active Parallel Power Filters (APPF). Both controllers are validated through the FPGA-in-the-loop (FIL) technique, the algorithm’s synthesis is accomplished using the Quartus II® platform, and the board used is from Altera®—Cyclone IV DE2-115. The main difference between the controllers resides in the power theories used to obtain the currents for compensation. The results confirm that the FPGA is a suitable digital device for the parallel operation of multiple compensators and calculation stages, being a viable solution for the requirements imposed in the control of APPF. Furthermore, the effectiveness of the FIL technique for validating the operation of digital circuits and control systems is also confirmed. Finally, a comparison between the processing costs of each of the implemented power theories is presented to guide novel proposals.

This article presents a study of the sampling rate effect on electrical power measurements whose definitions are based on the Conservative Power Theory (CPT). The definitions of active power and reactive power of the CPT were applied in the MATLAB® software by varying the sampling rate and using a digital power meter as a reference. The measurements were performed in scenarios with linear and non-linear loads. Due to the usage of an integral in the CPT calculus, an error was verified associated with the reactive power being inversely proportional to the sampling rate. From the present study, it is possible to conclude that depending on the sample rate, the errors associated with the reactive power measurements are unacceptable and make the CPT implementation unfeasible. The results also presented effective information about the minimal sampling rate needed to make these errors neglected and to assist in choosing suitable microprocessors for the digital implementation of the CPT. It is worth mentioning that this paper was limited to assess how accurate the measurements of active and reactive powers were and important to highlight that the CPT has the additional contribution of dealing with distortion currents and consequently new portions of powers. For the latter, the influence of sampling rate may be crucial and new lines of investigation are motivated.