Search

• Systematic study of 3d transition metal-doped CNTs. • V(Cr, Mn, Co)-doped CNTs show spin-polarization effects. • The 3d transition metal doping makes a big difference to the energy band. • 3d transition metal doping increases the quantum capacitance. • Ni-CNT has the largest quantum capacitance near zero potential. Supercapacitors are valued as one of the new green energy storage devices, but the low energy density limits the wide application of supercapacitors. In this paper, the effects of 3d transition metal doped on electronic structure and quantum capacitance of carbon nanotubes are investigated using DFT. The calculations show that elemental doping has caused the break-up of two degenerate states near the Fermi level, quasi-local state changes in the energy band, and the creation of new energy bands. The doping of V(Cr, Mn, Co) causes spin polarization in the energy band. The change in energy band affects the density of states near the Fermi level, effectively increasing the quantum capacitance and surface charge density of the carbon nanotube electrode. The quantum capacitance of Ni-doped carbon nanotubes is the largest, at 59.74 µF/cm2. In the range of water stability, Ti(V, Gr, Mn, Co)-CNT are suitable for use as electrode materials in symmetrical double layer supercapacitors. Sc(Fe, Cu, Zn)-CNT is suitable for use as anode materials in asymmetric double layer supercapacitors. Ni-CNT is suitable for use as a cathode material for asymmetric double layer supercapacitors. This study verifies the feasibility of 3d transition metal doping to improve the quantum capacitance of carbon nanotube electrodes. [Display omitted] [ABSTRACT FROM AUTHOR]

In this paper, a series of Li 3-x Na x V 2 (PO 4 ) 3 (0 ≤ x ≤ 3) are prepared by a solid state reaction and systematically evaluated as anode materials for lithium-ion batteries. Structural analysis shows that the phase structure of Li 3-x Na x V 2 (PO 4 ) 3 changes along with the evolution of Na content. Charge-discharge tests exhibit that Li 3 V 2 (PO 4 ) 3 shows the highest initial charge specific capacity as high as 88.3 mAh g −1 among all the seven samples, and the reversible capacity is kept at 68.3 mAh g −1 after 45 cycles, corresponding to 77.3% of the initial charge capacity. With increasing of Na content in Li 3-x Na x V 2 (PO 4 ) 3 , the as-obtained sample show poorer lithium storage capability than Li 3 V 2 (PO 4 ) 3 . As a result, Na 3 V 2 (PO 4 ) 3 shows the inferior cycling performance than other Li 3-x Na x V 2 (PO 4 ) 3 . It can only deliver a reversible capacity of 20.9 mAh g −1 after 45 cycles, corresponding to 45.9% of the initial charge capacity. In-situ X-ray diffraction observations demonstrate that the poor electrochemical property of Na 3 V 2 (PO 4 ) 3 anode is due to the irreversible structural evolution during charge-discharge process. Therefore, reducing the Na 3 V 2 (PO 4 ) 3 phase in as-obtained sample is a feasible route to improve the lithium storage capability of Li 3-x Na x V 2 (PO 4 ) 3 . [ABSTRACT FROM AUTHOR]