Search

SUMMARY The accurate magnetic properties of electrical steel sheets are important for the development of high-efficiency electromagnetic devices. In particular, the H-coil method is a useful technique for accurately measuring magnetic field strength in a single sheet tester. Therefore, we developed a tester for magnetic field properties using the H-coil method, referred to as the stress load type single sheet tester (S-SST), and a problem was found in iron loss measurement at a high flux density of 1.6 T or more. In this paper, it is shown that the cause of this problem is the phase difference between the induced voltage in the H-coil and the B-coil. Because the phase difference makes the B-H loop slightly twisted near the tip point, the iron losses are evaluated low. Thus, we propose a method of determining the phase correction values. These values are measured in the absence of a specimen in the S-SST measurement system, and the phase correction method for induced voltage in a coil is investigated. Finally, ideal results for the correction of iron loss in nonoriented electrical steel sheets are shown. The proposed method is effective for the calibration of a single sheet tester using the H-coil method. [ABSTRACT FROM AUTHOR]

The influence of stresses on the magnetic properties of nonoriented electrical steels was studied. The dependence of iron loss on compressive stress was affected by grain size. The magnetic polarization J in strong magnetic fields such as 5000 and 10,000 A/m increased due to compressive stresses and decreased due to tensile stresses in samples with low Si content. Using Kerr-effect domain observation, it was found that the reduction in J caused by tensile stresses was attributable to residual striped domains. Magnetostriction measurements in strong magnetic fields indicated that the increase in J under compressive stresses originated from the Villari effect (inverse magnetostrictive effect) due to negative magnetostriction in low-Si materials. © 2012 Wiley Periodicals, Inc. Electr Eng Jpn, 182(4): 10-18, 2013; Published online in Wiley Online Library (wileyonlinelibrary.com). DOI 10.1002/eej.22320 [ABSTRACT FROM AUTHOR]

This paper presents the measured magnetostriction of electrical steel sheets under alternating magnetic flux conditions. In the measurements, we used a two-dimensional vector magnetic property measurement system, and a three-axial strain gauge. In order to know the magnetostriction in an arbitrary direction, the strain tensor was evaluated. In addition, we try to evaluate the magnetostrictions in the thickness direction. In this paper, the three-dimensional magnetostriction in nonoriented and grain-oriented silicon steel sheets are compared. © 2012 Wiley Periodicals, Inc. Electr Eng Jpn, 179(4): 1-9, 2012; Published online in Wiley Online Library (). DOI 10.1002/eej.21257 [ABSTRACT FROM AUTHOR]

The two-dimensional vector magnetic properties are proposed as a method to express the magnetic anisotropy and iron loss precisely by using the relationship between the flux density vector and the magnetic field strength vector. The E&S modeling [6] and the E&SS modeling [7–9] have enabled the representation of the two-dimensional vector magnetic properties in FEM calculations. However, the calculated flux density waveform at each element has a phase difference depending on the excitation condition. In this paper, we have improved the E&SS modeling to solve the magnetic field problems under any exciting condition. © 2007 Wiley Periodicals, Inc. Electr Eng Jpn, 160(1): 1–9, 2007; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/eej.20446 [ABSTRACT FROM AUTHOR]