Search

Research about Hybrid Upflow-Anaerobic Filter (HU-AF) integrated technology for bioenergy generation from vinasse was conducted. Modification of influent flow system, expansion of filter contact area and addition of gas accumulator for biogas collection were used to enhance the degree of vinasse biodegradation biogas generation, and yet to shorten the hydraulic retention time (HRT). Hybrid Upflow-Anaerobic Filter (HU-AF) integrated technology was a double dome reactor with sequential connection, with up-flow inlet distribution inside the reactor. Total volume of HU-AF was 60 m3. A mixing and a feeding chamber, with volume 3 m3, each were installed before HU-AF reactor. A reservoir chamber with volume of 6 m3 was added after HU-AF reactor. OLR was 2.04 kg COD/day. A methanogenic seed sludge derived from anaerobic lagoon. The experiment was carried out initially by seeding, acclimatization and adaptation of microorganisms inside the reactor. A feeding ratio of vinasse: water = 1:4, and initial pH of 6 were adjusted. Result showed that Full-scale HU-AF integrated technology was able to degrade COD with maximum degradation of COD 55.45% at pH 7.1, and shorten the HRT into 32 days. Biogas production was consisted of 57.21 % methane, 13.98% CO2 and various gases 28.1% (H2S, VOC, CO and H2O). This experiment showed that HRT was shorter than conventional reactor.

Energy resources are gradually scarce and expensive. Raised a gap between increasing demand and energy supply. Bridging gap of demand together with energy supply by increase energy supplies is a very costly decision. Moreover, in the industrial sector with the high cost of energy, the longer the competitiveness decreases. Energy costs in total production costs reduce the number of profits each year. The strategy to prevent these problems is by increasing the efficiency of industrial operations and equipment. Several stages of the efficiency process begin with identifying balance, energy-saving opportunities, and energy utilization. This stage is better known as an energy audit. The advanced stage of the energy audit helps identify potential energy conservation and encourages the industry to focus on efficiency and conservation and is supported by adequate financing. In the research strategy, the opportunity to save energy costs in oil boiler units is practical, sustainable and economically feasible. On the results of measurements and calculations obtained boiler efficiency of 53.67% where the factors that cause the low efficiency of this boiler are the high excess water by 17.32% and heat loss from dry exhaust gas by 42.03%. The solution is done by controlling excess air by regulating the air entering the combustion chamber. In this way, energy savings can be increased by 15%.