Search

The study investigated two mandibular positions based upon computerized axiography recordings of hinge axis movements of 262 subjects. Next to the well-known guided closure position RP (reference position by chin-point guidance), the position of final deglutition (FD) was quantified. FD represented the hinge axis position at the end of the swallowing movement. The results elicited average linear distances of 0.32 +/- 0.43 mm on the right and 0.33 +/- 0.40 mm on the left side between both positions in the sagittal plane. The average distance in the frontal plane was 0.02 mm (right) and 0.04 mm (left). Approximately 46 per cent of FD recordings were found anterior and inferior to RP, and showed significant difference to posterior and anterior-superior FD recordings. The replicability of both positions was tested on 53 subjects and averaged 0.04 mm (FD) and 0.09 mm (RP). Average deviations of repeated recordings within the subject ranged from 0.07 to 0.47 mm (FD) and 0.07 to 0.57 mm (RP) for each spatial direction. The results of this study showed a relative coincidence of an average FD and RP Variation of FD in anterior inferior direction questioned the clinical reliability of FD to reassure the guided closure position.

Computerized axiography was used as an objective instrumental method of evaluating the response of patients with temporomandibular joint (TMJ) symptomatology to occlusal splint therapy. Diagnosis was performed in a standardized manner by systematically analyzing TMJ path tracings obtained by computerized axiography. Thirty-six patients were axiographed before and after therapy with full-arch occlusal stabilizing appliances, followed by assessing the effect of therapy on various path curve parameters. The data obtained for the patient group treated with splints was compared to that of six patients also axiographed, but left untreated for a period of six weeks before a second TMJ tracing was obtained. The results show that splints have a certain effect on reciprocal TMJ clicking (response rate 67%). Retral stability and path characteristics are also substantially improved (response rates 44% and 40%). Less influence was noted on hypomobile joint paths (response rate 29%), the quality of movements (response rate 28%) and Bennett angle values (response rate 23%). Patients with disk displacements without reduction were not treated with splints, they underwent surgery. Their results will be reported later. By contrast, TMJ tracings in the control group remained essentially unchanged.

Unguided protrusive and retrusive mandibular movement was investigated in 76 asymptomatic volunteers and temporomandibular joint (TMJ) patients using computerized axiography. In 38 of these subjects, guided pro-/retrusion was also recorded. Measurements were performed in a three-dimensional Cartesian coordinate system (x = anteroposterior; y = transversal, toward the hinge axis; z = craniocaudal). Transversal shift (y) was measured and evaluated as well as the distance "s" and horizontal condylar inclination (HCl) at the point of maximum transversal deviation. The patterns of the tracings were analyzed with a view to diagnostic improvements. The objective of this study was to evaluate transversal shift and to examine the postulate of symmetrical behavior of the TMJs in pro-/retrusion. The mean mandibular shift was 0.15 mm to the left. This maximum deviation was seen in a mean distance "s" of 7.42 mm in relation to the Cartesian coordinate system in reference position. These results suggest a functional dominance of the right part of the mandible in protrusive and retrusive movement.

The objective of this series is to observe and analyze movements of the temporomandibular joint (TMJ). With the information from these studies, orthopedic standards for jaw movements will be established in further investigations according to the neutral-zero method used in general orthopedics. Any restricted range of motion can thus be defined as a deviation from these standards. Direct interpretation and objective evaluation of joint functions has major practical implications. With the aid of computerized axiography, mediotrusive movements of 48 asymptomatic volunteers and 66 jaw patients were evaluated. The movements performed were either free or guided. The mean curve lengths, as well as the Bennett angles at 3 mm and at the end point were recorded. An average group was defined, containing the values of 50% of all volunteers. The interquartile range was calculated for lengths of mediotrusive movements as well as for Bennett angles. The average range of free mediotrusive movement for female volunteers was 11.06-11.98 mm (mean 11.55 mm) on the right side and 10.47-11.75 mm (mean 11.24 mm) on the left side. Male volunteers showed an average range of 10.23-11.54 mm (mean 11.1 mm) on the right side and 10.24-11.73 mm (mean 11.12 mm) on the left side. The values for female patients amounted to 9.95-1.66 mm (mean 10.8 mm) on the right side and 9.75-11.28 mm (mean 10.55 mm) on the left side. The average range for male patients was 9.06-9.71 mm (mean 9.54 mm) on the right side and 9.17-10.23 mm (mean 9.73 mm) on the left side. The average range for Bennett angles at maximum excursion in free mediotrusive movement was between 0.41 and 5.89 degrees (mean 4.43 degrees) in the volunteers on the right side and between 2.45 and 10.07 degrees (mean 6.87 degrees), respectively, on the left side. The values for patients amounted to 0.19-12.65 degrees (mean 6.93 degrees), on the right side and 1.71-14.15 degrees (mean 6.73 degrees) on the left side.

This paper reviews earlier methods for the analysis of mandibular movement and gives a detailed account of state-of-the-art procedures. Special emphasis is given to computerized axiography and the application of this method to the diagnostics of the temporomandibular joint (TMJ). The article discusses the advantages of computerized axiography over the mechanical device and points out the limitations of the axiographic method. One major advantage of the computerized system is having the enlarged diagram of tracings on the computer screen. This means that small changes such as initial disk displacements can be diagnosed more readily than with the mechanical device.