Search

A six-component handrim dynamometer (HRD) is a dynamometer that rotates around the wheel axle during measurements. For this kind of dynamometer, static zero level calibration is insufficient because the proportion of the forces (i.e. handrim weight and centrifugal force) measured by each sensor varies according to the angular position and velocity of the dynamometer. The dynamic calibration presented in this paper is based on the direct correction of the sensor signals using Fourier's polynomials that take into account the influences of both the handrim weight distribution on the sensors with respect to the wheel's angular position and the effect of the wheel's angular velocity. When these corrections were applied to the signals produced by the sensors while the HRD was rotating and no effort was being exerted on the handrim, the calculated forces and torques remained close to zero, as expected. Based on these results, the wheel dynamometer can be confidently used for studying manual wheelchair locomotion under various real conditions. The method could also be applied in other situations in which a dynamometer rotates during measurements. [ABSTRACT FROM AUTHOR]

This article presents an examination and validation of a method to measure the field deceleration of a manual wheelchair (MWC) and to calculate the rolling resistances properties of the front and rear wheels. This method was based on the measurements of the MWC deceleration for various load settings from a 3D accelerometer. A mechanical model of MWC deceleration was developed which allowed computing the rolling resistance factors of front and rear wheels on a tested surface. Four deceleration sets were conducted on two paths on the same ground to test the repeatability. Two other deceleration sets were conducted using different load settings to compute the rolling resistance parameters (RPs). The theoretical decelerations of three load settings were computed and compared with the measured decelerations. The results showed good repeatability (variations of measures represented 6–11% of the nominal values) and no statistical difference between the path results. The rolling RPs were computed and their confidence intervals were assessed. For the last three sets, no significant difference was found between the theoretical and measured decelerations. This method can determine the specific rolling resistance properties of the wheels of a MWC, and be employed to establish a catalogue of the rolling resistance properties of wheels on various surfaces. [ABSTRACT FROM PUBLISHER]