Search

Abstract: The flatwise compressive behaviour of tetrachiral and hexachiral honeycombs is analysed, using analytical and Finite Element simulations, both with explicit and implicit formulations. The tetrachiral and hexachiral cells are composed by cylinders connected by four and six tangent ligaments respectively. The ligaments act as mixed stiffeners-elastic foundations during flatwise compressive loading, providing different buckling mode shapes during deformation. The models are compared with experimental results obtained using RP-based honeycombs tested according to ASTM C 393-00 and ASTM C365-00. [Copyright &y& Elsevier]

Abstract: Numerical procedures based on the combined use of the Virtual Crack Closure Technique and of a fail release approach have been widely used to simulate delamination growth phenomena of composite material structures. This paper starts explaining why this kind of methodologies might not be robust due to mesh and load step size dependency and introduces a novel approach able to cope with the problems identified. Finally the effectiveness and robustness of the proposed procedure, implemented into a commercial finite element software by means of user subroutines, are assessed by comparing the obtained numerical results for a delamination growth phenomenon against literature experimental data on a stiffened panel with a circular embedded delamination under compressive load. [Copyright &y& Elsevier]

Abstract: A fuselage representative carbon fibre-reinforced multi-stiffener panel is analysed under compressive loading. An intact and pre-damaged configuration is loaded into the postbuckling region and further on until collapse occurs. An analysis tool is applied that includes an approach for predicting interlaminar damage initiation and degradation models for capturing interlaminar damage growth as well as in-plane damage mechanisms. Analysis of the intact panel configuration predicts collapse due to fibre fracture in the stiffeners close to the panel clamps, which agrees well with the results from experimental testing. The pre-damaged configuration was proposed containing Teflon-coated layers to generate the initial debonds in the skin-stiffener interface. The outcome of the simulation of this configuration shows that crack growth is not predicted to occur, which agrees with the observations of the experiment. A parametric study is conducted to investigate the effect of the skin-stiffener debond parameters such as length, width and location on crack growth and the collapse behaviour of the panel. It is found that the sensitivity of the panel design to the damage parameters is highly dependent on the postbuckling mode shape or displacement pattern, and particularly the extent to which this influences the conditions at the crack front. More broadly, the analysis tool is shown to be capable of capturing the critical damage mechanisms leading to structural collapse of stiffened composite structures in the postbuckling region. [Copyright &y& Elsevier]