Search

The present study compared the tensile and low velocity impact (LVI) response of Kevlar/basalt fabrics. Homogeneous and hybrid fabrics with structures of two dimensional plain woven (2D-P) and three dimensional angle-interlock (3D-A) were woven with Kevlar and basalt yarns. Interlacing of brittle basalt yarns with high-ductility/high-toughness Kevlar yarns enhanced the tensile strength of 2D-P fabrics by 5.39–50.29% and 3D-A fabrics by 14.80%. Similarly hybridization enhanced the energy absorption of 2D-P fabrics by 8.58–37.71% and 3D-A fabrics by 13.45–20.14%. Change in the architecture from 2D-P to 3D-A also enhanced the tensile and impact resistance of fabrics. Different failure modes induced due to tensile and LVI loads were identified. [ABSTRACT FROM AUTHOR]

In this study, experimental investigations on Kevlar fiber reinforced polypropylene (PP) woven composites under high strain rate compression loading are discussed. Kevlar/PP composite laminates with 8 and 24 layers are fabricated using vacuum assisted compression molding technique. Maleic anhydride grafted-PP (MAg-PP) is added to PP to improve the interfacial property between Kevlar fiber and PP resin. The through-thickness properties at high strain rates from 1370 to 6066 s −1 are obtained using split Hopkinson pressure bar (SHPB) setup. The behavior of PP resin is found to be different than the commonly used thermoset resins, such as epoxy. Dynamic stress–strain relations are drawn to reveal the mechanical properties at high strain rates and these relations appear to be rate sensitive. As a result, the peak stress increased by three times, toughness increased by almost ten times and strain at peak stress increased by as much as two times with an increase in the strain rate. The final failure of the specimens is examined by scanning electron microscopy (SEM) to explore the possible failure mechanisms such as, delamination, fiber failure and shear fracture. [ABSTRACT FROM AUTHOR]