Search

A new heuristics model based on the Voronoi diagram is presented to simulate pedestrian dynamics with the non-crowded state, in which these mechanisms of preference demand evading and surpassing, microscopic anti-deadlock, and site-fine-tuning are considered. The preference demand describes the willingness determination of detouring or following other pedestrians. In the evading and surpassing mechanisms, in order to achieve a balance between avoiding conflicts and minimizing detour distances, a new pair of concepts: “allow-areas and denial-areas” are introduced to divide the feasible region for pedestrians detour behaviors, in which the direction and magnitude of detour velocity are determined. A microscopic anti-deadlock mechanism is inserted to avoid deadlock problem of the counter-directional pedestrian. A site-fine-tuning mechanism is introduced to describe the behavior of avoiding getting too close to the neighbors in pedestrian movement. The presented model is verified through multiple scenarios, including the uni- or bi-direction pedestrian flow in the corridor without obstacles, the uni-direction pedestrian flow in the corridor with obstacles, and the pedestrian evacuation from a room with single-exit. The simulation results show that the velocity–density relationship is consistent with empirical data. Some self-organizing phenomena, such as lanes formation and arching are observed in the simulation. When pedestrians detour an obstacle, the avoiding area before the obstacle and the unoccupied area after the obstacle can be observed. When pedestrians evacuate through a bottleneck without panic, the fan-shaped crowd can be found, which is consistent with the actual observation. It is also found that the behavior of following others in an orderly manner is more conducive to the improvement of the overall movement efficiency when the crowd moves in a limited space.

AlGaN/GaN heterostructures on vicinal sapphire substrates and just-oriented sapphire substrates (0001) are grown by the metalorganic chemical vapor deposition method. Samples are studied by high-resolution x-ray diffraction, atomic force microscopy, capacitance–voltage measurement and the Van der Pauw Hall-effect technique. The investigation reveals that better crystal quality and surface morphology of the sample are obtained on the vicinal substrate. Furthermore, the electrical properties are also improved when the sample is grown on the vicinal substrate. This is due to the fact that the use of vicinal substrate can promote the step-flow mode of crystal growth, so many macro-steps are formed during crystal growth, which causes a reduction of threading dislocations in the crystal and an improvement in the electrical properties of the AlGaN/GaN heterostructure.

This paper studies the degradation of device parameters and that of stress induced leakage current (SILC) of thin tunnel gate oxide under channel hot electron (CHE) stress at high temperature by using n-channel metal oxide semiconductor field effect transistors (NMOSFETs) with 1.4-nm gate oxides. The degradation of device parameters under CHE stress exhibits saturating time dependence at high temperature. The emphasis of this paper is on SILC of an ultra-thin-gate-oxide under CHE stress at high temperature. Based on the experimental results, it is found that there is a linear correlation between SILC degradation and Vh degradation in NMOSFETs during CHE stress. A model of the combined effect of oxide trapped negative charges and interface traps is developed to explain the origin of SILC during CHE stress.

Electromagnetic field distribution in the vertical metal organic chemical vapour deposition (MOCVD) reactor is simulated by using the finite element method (FEM). The effects of alternating current frequency, intensity, coil turn number and the distance between the coil turns on the distribution of the Joule heat are analysed separately, and their relations to the value of Joule heat are also investigated. The temperature distribution on the susceptor is also obtained. It is observed that the results of the simulation are in good agreement with previous measurements.

This paper reports on a comparative study of the spatial distributions of the electrical, optical, and structural properties in an AlGaN/GaN heterostructure. Edge dislocation density in the GaN template layer is shown to decrease in the regions of the wafer where the heterostructure sheet resistance increases and the GaN photoluminescence band-edge energy peak shifts to a high wavelength. This phenomenon is found to be attributed to the local compressive strain surrounding edge dislocation, which will generate a local piezoelectric polarization field in the GaN layer in the opposite direction to the piezoelectric polarization field in the AlGaN layer and thus help to increase the two-dimensional electron gas concentration.

This paper discusses the effect of N2 plasma treatment before dielectric deposition on the electrical performance of a Al2O3/AlGaN/GaN metal-insulator-semiconductor high electron mobility transistor (MISHEMT), with Al2O3 deposited by atomic layer deposition. The results indicated that the gate leakage was decreased two orders of magnitude after the Al2O3/AlGaN interface was pretreated by N2 plasma. Furthermore, effects of N2 plasma pretreatment on the electrical properties of the AlGaN/Al2O3 interface were investigated by x-ray photoelectron spectroscopy measurements and the interface quality between Al2O3 and AlGaN film was improved.

The effect of substrate bias on the degradation during applying a negative bias temperature (NBT) stress is studied in this paper. With a smaller gate voltage stress applied, the degradation of negative bias temperature instability (NBTI) is enhanced, and there comes forth an inflexion point. The degradation pace turns larger when the substrate bias is higher than the inflexion point. The substrate hot holes can be injected into oxide and generate additional oxide traps, inducing an inflexion phenomenon. When a constant substrate bias stress is applied, as the gate voltage stress increases, an inflexion comes into being also. The higher gate voltage causes the electrons to tunnel into the substrate from the poly, thereby generating the electron–hole pairs by impact ionization. The holes generated by impact ionization and the holes from the substrate all can be accelerated to high energies by the substrate bias. More additional oxide traps can be produced, and correspondingly, the degradation is strengthened by the substrate bias. The results of the alternate stress experiment show that the interface traps generated by the hot holes cannot be annealed, which is different from those generated by common holes.

To reveal the internal physics of the low-temperature mobility of two-dimensional electron gas (2DEG) in Al-GaN/GaN heterostructures, we present a theoretical study of the strong dependence of 2DEG mobility on Al content and thickness of AlGaN barrier layer. The theoretical results are compared with one of the highest measured of 2DEG mobility reported for AlGaN/GaN heterostructures. The 2DEG mobility is modelled as a combined effect of the scattering mechanisms including acoustic deformation-potential, piezoelectric, ionized background donor, surface donor, dislocation, alloy disorder and interface roughness scattering. The analyses of the individual scattering processes show that the dominant scattering mechanisms are the alloy disorder scattering and the interface roughness scattering at low temperatures. The variation of 2DEG mobility with the barrier layer parameters results mainly from the change of 2DEG density and distribution. It is suggested that in AlGaN/GaN samples with a high Al content or a thick AlGaN layer, the interface roughness scattering may restrict the 2DEG mobility significantly, for the AlGaN/GaN interface roughness increases due to the stress accumulation in AlGaN layer.

In this paper, we have discussed the effect of electrical stress on GaN light emitting diode (LED). With the lapse of time, the LED with an applied large current stress can reduce its current more than without such a stress under a large forward-voltage drop. Its scanning electron microscopy (SEM) image shows that there exist several pits on the surface of the p-metal. With an electrical stress applied, the number of pits greatly increases. We also find that the degradation of GaN LED is related to the oxidized Ni/Au ohmic contact to p-GaN. The electrical activation of H-passivated Mg acceptors is described in detail. Annealing is performed in ambient air for 10 min and the differential resistances at a forward-voltage drop of 5 V are taken to evaluate the activation of the Mg acceptors. These results suggest some mechanisms of degradation responsible for these phenomena, which are described in the paper.

This paper studies systematically the drain current collapse in AlGaN/GaN metal-oxide-semiconductor high electron mobility transistors (MOS-HEMTs) by applying pulsed stress to the device. Low-temperature layer of Al2O3 ultrathin film used as both gate dielectric and surface passivation layer was deposited by atomic layer deposition (ALD). For HEMT, gate turn-on pulses induced large current collapse. However, for MOS-HEMT, no significant current collapse was found in the gate turn-on pulsing mode with different pulse widths, indicating the good passivation effect of ALD Al2O3. A small increase in Id in the drain pulsing mode is due to the relieving of self-heating effect. The comparison of synchronously dynamic pulsed Id - Vds characteristics of HEMT and MOS-HEMT further demonstrated the good passivation effect of ALD A12O3.