Search

The number of restaurants is increasing day by day in almost all the developing countries, causing the increase in the generation of restaurant wastewater. Various activities (i.e., cleaning, washing, and cooking) going on in the restaurant kitchen lead to restaurant wastewater (RWW). RWW has high concentrations of chemical oxygen demand (COD), biochemical oxygen demand (BOD), nutrients such as potassium, phosphorus, and nitrogen, and solids. RWW also contains fats, oil, and grease (FOG) in alarmingly high concentration, which after congealing can constrict the sewer lines, leading to blockages, backups, and sanitatry sewer overflows (SSOs). The paper provides an insight to the details of RWW containing FOG collected from a gravity grease interceptor at a specific site in Malaysia, and its expected consequences and the sustainable management plan as prevention, control, and mitigation (PCM) approach. The results showed that the concentrations of pollutants are very high as compared to the discharge standards given by Department of Environment, Malaysia. Maximum values for COD, BOD and FOG in the restaurant wastewater samples were found to be 9948, 3170, and 1640 mg/l, respectively. FAME and FESEM analysis are done on the RWW containing FOG. In the FOG, palmitic acid (C16:0), stearic acid (C18:0), oleic acid (C18:1n9c), linoleic acid (C18:2n6c) are the dominant lipid acids with a maximum of 41, 8.4, 43.2, and 11.5%, respectively. FESEM analysis showed formation of whitish layers fprmed due to the deposition of calcium salts. Furthermore, a novel design of indoor hydromechanical grease interceptor (HGI) was proposed in the study based on the Malaysian conditions of restaurant. The HGI was designed for a maximum flow rate of 132 L per minute and a maximum FOG capacity of 60 kg. [Display omitted] • Characterization and analysis of restaurant wastewater containing FOG was conducted. • Peak flow discharge was measured at the gravity grease interceptor which was the sampling point during the study. • FAME & FESEM analysis was carried on the composition of FOG in restaurant wastewater. • Design of Hydromechanical grease interceptor was proposed for the indoor and onsite installation to control the FOG. • Prevention, control, and mitigation approach to combat the deleterious effects of FOG in RWW. [ABSTRACT FROM AUTHOR]

The use of sustainable materials in the construction industry has been on the rise recently. Studies have proven that the use of conventional concrete and its raw materials has a negative impact on the environment. Research on incorporating biochar as a supplementary cementitious material has been recently evolving and has shown that the attributes of biochar are highly affected by the pyrolysis parameters. These attributes have enhanced the properties of biochar concrete and mortar composite. This paper identifies the different physiochemical properties exhibited by palm kernel shell biochar through optimization by response surface methodology. Focusing on some of the properties of biochar that have proven beneficial when used as a cement replacement. Very limited research has used optimization tools for the production of biochar with the intention of using it as a cement substitute. Pyrolysis was conducted by a tubular furnace at different temperature ranges from 200 °C to 800 °C. The biomass and biochar have been analyzed with TGA and FESEM-EDX. The targeted biochar properties and selected responses are the yield, carbon, oxygen, silica, and potassium content. The optimized parameters obtained are 409 °C, 15 °C/min, 120 min with responses of 38.2% yield, 73.37% carbon, 25.48% oxygen, 0.39% potassium and 0.44% silica. Thermal properties of the palm kernel shell biochar affected by the pyrolysis factors such as temperature, heating rate and residence time have also been discussed. In conclusion, this study supports and encourages the use of palm waste, which is abundant in Malaysia, as a supplementary cementitious material to promote sustainable growth in construction. [Display omitted] • Hypothesis for a high potential of palm kernel shell biochar to be used as supplementary cementitious replacement. • The factors that are taken into consideration are pyrolysis temperature, heating rate and residence. The responses are biochar yield, carbon, oxygen, potassium, and silica content. • Optimized round of palm kernel shell biochar is 409 °C, 15 °C/min and 120 min. • The carbon content of the biochar is directly proportional to the pyrolysis temperature. • The pyrolysis temperature and residence time are more effective than heating rate on the physiochemical properties. [ABSTRACT FROM AUTHOR]

The introduction of new technology, such as the Internet of Things (IoT), entails a growth in digital devices, which could ultimately result in a high amount of electronic trash (e-waste) production if they are not appropriately managed. Apart from that, the regulation on possible "IoT E-waste" generation is yet to be regulated, probably due to the new development and implementation of IoT globally. Hence, this paper proposed a Sustainable IoT E-waste Management guideline for households. This guideline could assist government agencies and policymakers in their strategies, planning, development, and implementation of a sustainable household IoT e-waste management initiatives in Malaysia. This study is an exploratory study that adopts a qualitative case study research method. The guideline was developed based on the Integrated Sustainable Waste Management (ISWM) Model. This guideline contributes to Malaysia's sustainability agenda in reducing carbon emissions intensity towards 2030 by 45 percent. [Display omitted] • To propose Sustainable IoT E-Waste Guideline for Household caters. • To devise a strategy for the development and implementation of IoT projects. • To develope the guideline of Sustainable IoT E-waste Management for Household. • To introduce new phenomenon called "IoT E-waste". [ABSTRACT FROM AUTHOR]