Search

Abstract: The kinetic phase behavior and phase transformation paths of purified tristearoylglycerol (SSS), 3-palmitoyl-1,2-distearoyl-sn-glycerol (PSS) and 1,2-dipalmitoyl-3-stearoyl-sn-glycerol (PPS) were investigated in terms of polymorphism, crystallization and melting. The details of the phase transformation paths were obtained using the heating cycles of two sets of experiments: (a) cooling rate was varied and heating rate fixed and (b) cooling rate was fixed and heating rate varied. Kinetic effects were manifest in all measured properties, underscoring the complexity of the phase transformation paths for each TAG, and the intricate thermodynamics–molecular relationships. For the first time, XRD data obtained for SSS, PSS and PPS TAGs, cooled at rates higher than 0.5°C/min, suggested the formation of a transient structure similar to the so-called α2-phase which has been observed in mixed saturated–unsaturated TAGs quenched from the melt. The more stable phases (β′ in PSS and PPS, and β in SSS) were only observed for cooling rates lower than 1.0°C/min. The kinetic and thermodynamic differences observed in the crystallization, structure and melting of SSS, PSS and PPS are proposed to be mainly due to the disturbances introduced at the “terrace” level via methyl-end group interactions, i.e., the missing of two or four CH2 groups compared to SSS. The symmetrical SSS with a relatively flat “terrace” crystallizes preferably in the most stable β-form. Two missing CH2 groups at the sn-1 position (PSS) introduces enough structural disturbances to promote the relative prevalence and persistence of the β′-phase, and four missing CH2 groups at the sn-1 and sn-2 positions (PPS) is relatively too large of a disturbance and therefore favors the α-form. [Copyright &y& Elsevier]

Abstract: A robust, well-defined and reproducible method to accurately measure the oil binding capacity (OBC) of structuring fats was developed. The method was validated using two oil/fat model systems, i.e., fully hydrogenated canola oil (FHCO) in canola oil (CO) (FHCO/CO) and fully hydrogenated soybean oil (FHSO) in CO (FHSO/CO). The mixtures were crystallized from the melt down to three different temperatures (15, 25 and 35°C) at constant rates of cooling and the OBC was measured after different periods of storage time. The critical concentration of hard fat at which the solid fat network is stable and effectively binds oil has been also measured for mixtures crystallized at temperatures close to room temperature, i.e., 25°C. Crystal structure, melting behavior, microstructure, and solid fat content of these binary systems have been investigated in relation to the OBC of the solid fat network using X-ray diffraction (XRD), differential scanning calorimetry (DSC), polarized light microscopy (PLM), and wide-line pulsed nuclear magnetic resonance (pNMR) techniques. The two model systems exhibited similar trends in OBC over time, a behavior attributed to their similar TAG composition and polymorphism. However, relatively smaller OBC values were achieved by the CO/FHSO compared to CO/FHCO samples, largely due to differences in their solid network structure. Four successive decreasing linear segments, identifying successive mechanisms of oil migration/binding, were observed in the experimental OBC versus fat weight fraction curves. The critical concentration of hard fat, at which the solid fat network is effective in binding oil, was also determined and found to be ∼6wt% for both systems. [ABSTRACT FROM AUTHOR]

Abstract: The binary phase behavior of purified 1,3-dilauroyl-2-stearoyl-sn-glycerol (LSL) and 1,2-dilauroyl-3-stearoyl-sn-glycerol (LLS) was investigated at a slow (0.1°C/min) and a relatively fast (3.0°C/min) cooling rate in terms of melting and crystallization, polymorphism, solid fat content (SFC), hardness and microstructure. Much of the behavior of the system is explained by its polymorphism and the influence of thermal processing. The α-form and the β′-form of a double chain length structure were detected in the mixtures cooled at 3.0°C/min, whereas only the β′-form was detected in those cooled at 0.1°C/min. X-ray diffraction data as well as thermodynamic data propose that the most stable phases are promoted by the symmetrical LSL. The measured trends in structural characteristics, thermal properties, SFC, relative hardness and microstructure delimit three groups of mixtures which imply a competition between the stabilizing effect of LSL and disordering introduced by kinetic effects: (a) LLS-rich mixtures with LSL molar fractions (X LSL) less than 0.3, (b) mixtures with X LSL clustered around 0.5 and (c) LSL-rich mixtures with X LSL ≥0.7. The balance between ordering and kinetic effects determines the polymorphism of the mixtures, which in turn determines the behavior of the LSL/LLS system. The kinetic phase diagram of the LSL/LLS binary system constructed using heating differential scanning calorimetry thermograms displayed a singularity at the 0.5LSL molar fraction which delimits two distinct behaviors: eutectic behavior in one region and monotectic behavior in the other. The molecular interactions, as depicted by a non-ideality parameter of mixing obtained from a thermodynamic model based on the Hildebrand equation, suggests an almost ideal mixing behavior and a moderate tendency to the formation of unlike-pairs in the liquid state. [Copyright &y& Elsevier]