Search

• Hillslope erosion dynamic model integrating vegetation effect was established. • Unified baseline parameters were obtained across different land uses. • Effect of vegetation on soil detachment and sediment transport was revealed. • Contribution rates of vegetation to sediment reduction along slopes were quantified. Developing a process-based soil erosion model that comprehensively considers the effects of vegetation is complex but crucial for evaluating sediment reduction during vegetation restoration. Current understanding of the effect of vegetation on sediment reduction along hillslopes across different land uses is limited. In this paper, we developed a dynamic model of hillslope erosion that integrates the effects of vegetation on soil detachability and hydrodynamics (VED) based on the feedback mechanism between soil detachment and sediment transport. The VED was calibrated and validated with runoff plot data for woodland, grassland, and farmland in the Wuding, Yan, Jing and Wei Rivers of the Loess Plateau in China. Unified baseline parameters and decay coefficients of vegetation were obtained. The model validation results indicated that the coefficient of determination, Nash–Sutcliffe simulation efficiency and relative error ranged from 0.59 to 0.99, 0.56 to 0.90, and −45.99 % to 46.36 %, respectively. The decay coefficients for soil detachment capacity (Φ), sediment transport capacity (T c), and the sediment reduction effect of vegetation exhibited the following order: woodland > grassland > farmland. Compared with VED, existing process-based soil erosion models failed to effectively characterize the influence of vegetation on Φ and T c on the Loess Plateau, with differences of several orders of magnitude. The individual contributions of runoff, soil detachability, and hydrodynamics with vegetation impact on sediment yield were quantified by VED. The contribution rates of vegetation to sediment reduction decreased gradually with increasing slope length because the soil detachment capacity of bare slopes exceeded that of vegetated slopes, resulting in a faster increase in sediment yield. The contribution rates of vegetation to sediment reduction for woodland, grassland, and farmland with 20 %–60 % vegetation covers were 66.75 %–99.95 %, 57.43 %–99.63 %, and 27.91 %–88.63 % in the boundary conditions of this study, respectively. The results reveal the potential for integrating VED into other distributed watershed hydrological and sediment models to assess the effects of vegetation restoration on sediment reduction at a watershed scale. [ABSTRACT FROM AUTHOR]

• SY and Sr of the SL was the largest, but the sediment MWD was the smallest. • Change in the flow discharge did not affect the distribution pattern of sediment particles. • Dynamic coupling of runoff hydraulics and EG morphology drove soil loss. • SDR was the most direct influencing factor on the Sr in EGs. Ephemeral gully (EG) erosion represents the early stage of large-scale gully (locally named as "Benggang") development on Ultisols in the granite hilly area. However, the EG erosion process and the mechanism underlying sediment production have not been fully elucidated. In this study, a series of field scouring experiments were conducted under different flow discharge levels (10, 15, 20, 25, and 30 L·min−1), and the primary EGs in three typical soil layers with different weathering degrees (red soil layer (RL), transition layer (TL), and sandy layer (SL)) was dynamically monitored. The results indicated that the ratio of width to depth of the EGs rapidly decreased as the flow discharge increased. At 30 L·min−1, the average sediment yield and transport rate (Sr) of the SL were 4.85 and 5.39 times, greater than those of the RL, respectively. The sediment particles were concentrated within the 1–2 mm particle size range, accounting for over 35 %. In addition, the mean weight diameter of the sediment particles in the RL was the largest. The sediment distribution characteristics did not respond to flow changes but were affected by EG morphological changes. With increasing flow discharge, the flow shear stress and stream power increased. Further analysis revealed that the coupling effect of flow hydraulic characteristics and EG morphological evolution drove the EG erosion sediment production process, and the Sr of the SL was highly sensitive to flow discharge changes. The soil disintegration rate was an internal factor that directly affected soil loss in the EGs, with a path coefficient of 0.71. The bulk density, organic matter content, and sand content were all indirect influencing factors. The RL exhibited greater anti-erodibility than the other layers and could serve as an effective protective layer for granite hilly areas. These findings provide a theoretical basis for improving soil loss management systems. [ABSTRACT FROM AUTHOR]

• It is essential to utilize diverse sources of observational data for the validation of long-term morphological simulations. • The multiple underlayer settings of the Delft3D model enable its acquisition of decadal bed layer stratigraphy. • Wind and waves sort sediment based on grain size, smoothing out morphological changes induced by tides. • Sea level rise significantly influences regions characterized by intricate morphological features. • Radial sand ridges form under a radial regime with low tidal ellipticity, abundant sand, and minor cohesive sediment. The tidal sand ridges in the southwestern Yellow Sea are unique in the world characterized by radial morphology, significantly higher elevation above low water level, and fine-grained sediment deposits. Using a numerical model, we examined the morphological evolution of the radial sand ridge system from 1979 to 2059. The model was calibrated and validated using hydrodynamic and sediment transport data, seabed topography, and grain size distributions from sediment cores. Our findings reveal that tidal force is the primary driver of the ridges' evolution, and they will continue to expand in response to sediment supply from the abandoned Yellow River delta and the Yangtze delta, with the latter contributing more. The ridges are mainly composed of fine sand and mud, with finer sediment dominating in the north and coarser sediment dominating in the south. Wind and waves sort sediment, depositing sand on ridges and fine sediment in channels, leading to erosion of higher elevated lands and filling of deep channels. Sea-level rise increases regional erosion, which has a large impact on areas with complex morphology. The 500-year morphological evolution of sand ridge systems, simulated through an idealized model, illustrated that the formation of radial sand ridges is dependent upon specific conditions such as the radial tidal regime, sufficient sediment sand, and the presence of cohesive sediment. This study deepens our understanding of the long-term prediction of coastal morphology and interpretation of seabed stratigraphy, and offers insights for effective coastal management. [ABSTRACT FROM AUTHOR]

• Mass movement is an important erosion mode and sediment source in gully network. • Mass movement increased sediment concentration and led to peak sediment concentration. • Mass movement was prone to be triggered by rainfall with a medium-duration and moderate-intensity. • Rainfall amount and slope gradiet determined the trigger and total volume of mass movement. Mass movement erosion on the gully sidewalls is recognized as an important erosion mode and sediment source in hilly and gully watersheds. However, the trigger of mass movement erosion and transport of gravity-detached material remain poorly understood. A series of rainfall simulation experiments were conducted on six loess gully sidewall models, with a height (1 m), three rainfall (60 mm, 48 mm and 24 mm) and two slope gradients (70° and 80°), to quantitatively explore the sensitivity factor and transport mechanisms of mass movement. Results revealed that the accumulation volume and initiation of the mass failure were significantly influenced by rainfall amount. The accumulative volume of failure events was observed to increase in a linear pattern with increasing rainfall amount. The minimum cumulative rainfalls for the initiation of mass failure on the loess gully sidewalls were approximately 43.6, 28.2 and 65.6 mm for short-duration and high-intensity, medium-duration and moderate-intensity and short-duration and moderate-intensity rainfalls, respectively. This implied that the initiation of mass failure was more prone to rainfall events with a medium-duration and moderate-intensity than those with a high intensity and short duration. Rainfall amount and initial slope gradient were the most sensitive elements driving the number and volume of the mass movement erosion. Mass movement erosion raised sediment concentration, but the eroded material was unable to be transported by runoff in a timely manner. Average sediment concentrations at the model outlet increased by 1.9–11.9 times following the occurrence of mass failures compared to those before. A low instantaneous sediment delivery ratio of 0.032 for the mass movement erosion. The experimental findings help comprehend the influence of mass movement erosion on sediment supply on the gully sidewall in the hilly and gully network, i.e. the Loess Plateau. [ABSTRACT FROM AUTHOR]