Search

The paper describes load and resistance factor design (LRFD) calibration for the resistance factor used in the Stiffness Method internal stability soil failure limit state for geogrid mechanically stabilized earth (MSE) walls. The Stiffness Method was recently adopted in the current American Association of State Highway and Transportation Officials LRFD Bridge Design Specifications in the US, and will appear in the next edition of the Canadian Highway Bridge Design Code. The paper describes the details of the calibration of the soil failure limit state which is unique to the Stiffness Method. Calibration outcomes include consideration of the concept of level of understanding in the selection of nominal load and resistance values which is unique to LRFD foundation engineering practice in Canada. A practical conclusion from these calculations is that if product line-specific creep test data are available to estimate the reinforcement secant creep stiffness used for design, then a resistance factor of 1.0 is reasonable for US practice. If only minimum average roll value tensile strength data are available, then a value of 0.95 is recommended for US practice. For Canadian practice, the corresponding values for typical level of understanding are 0.90 and 0.85, respectively. [ABSTRACT FROM AUTHOR]

The next edition of the Canadian Highway Bridge Design Code will contain a table of geotechnical resistance factors to be used for seismic design. This paper will estimate the geotechnical resistance factors for shallow foundations required to achieve various target maximum acceptable failure probabilities, which in turn may depend on the assumed design earthquake return period. The investigation will include consideration of design lifetime, uncertainty in the magnitude of the maximum lifetime earthquake event, and the uncertainty in ground properties. The results suggest resistance factors that are lower than commonly used at the moment in Canada and that the failure probability is not greatly dependent on the return period of the design earthquake. The paper will present recommendations on geotechnical resistance factors for seismic design that can be used to guide and calibrate future editions of civil design codes in Canada. [ABSTRACT FROM AUTHOR]