Search

The paper presents the numerical modelling details using the finite difference method (FDM) to simulate the performance of a well-instrumented geogrid-reinforced incremental concrete panel soil retaining wall. Two different constitutive models were investigated for the backfill soil (linear elastic-plastic model and nonlinear elastic-plastic model). Both constant stiffness and strain-dependent secant stiffness models were used for the reinforcement elements. The paper provides valuable lessons to modellers to simulate the performance of this type of earth retaining structure. For example, parametric investigation of the effect of a constant Young's modulus ranging from 40 to 120 MPa for the linear-elastic Mohr-Coulomb model had only minor influence on the wall facing displacements and reinforcement loads. However, the choice of magnitude of transient compaction pressure near the facing can result in large differences in facing displacements. The paper also demonstrates that the method of construction including the location, sequence, and stiffness of the temporary supports used to construct the wall plays an important role on measured and predicted wall performance. The physical measurements reported in this paper provide a benchmark for numerical modellers to verify other numerical models for walls of the type investigated here. [ABSTRACT FROM AUTHOR]

The paper describes limit equilibrium analyses of two large-scale geosynthetic reinforced soil embankments and one unreinforced soil embankment that were taken to collapse under a strip footing placed close to the crest. One reinforced embankment was constructed with a relatively extensible and weak polypropylene geogrid and the second with a relatively strong and stiff high-density polyethylene geogrid. The geometry of the embankments and the loading arrangement were the same for all three structures. The focus of the paper is on a comparison of the predicted collapse load for the three structures and the actual observed values. A three-dimensional analytical approach is used to account for possible side-wall friction effects due to the test facility in which the large-scale experimental models were built. The paper also reports details on the interpretation of in-isolation constant load tests and strain measurements used to infer tensile loads in the reinforcement at failure. An important conclusion is that a general two-part wedge analysis approach can be used to predict the collapse footing load for both unreinforced and reinforced sand embankments in this investigation provided careful attention is paid to the selection of soil shear strength and reinforcement tensile capacity. [ABSTRACT FROM AUTHOR]

The paper describes an experimental investigation in which two large-scale geosynthetic reinforced soil embankments and one unreinforced soil embankment were taken to collapse under a strip footing placed close to the crest. One reinforced embankment was constructed with a relatively extensible and weak polypropylene geogrid and the second with a relatively strong and stiff high-density polyethylene geogrid. The geometry of the unfaced embankments, sand soil, and loading arrangement were the same for all three structures. The focus of the paper is on the experimental design, construction, testing, and instrumentation techniques used in the investigation and selected test results. The results of the study show that the ultimate footing load capacity increased with an increase in reinforcement strength (and stiffness) and that the reinforced soil embankments had a load capacity up to 1.6–2.0 times that of the nominal identical control embankment without reinforcement. [ABSTRACT FROM AUTHOR]