Search

A combination of steam explosion (SE) and chemical pretreatments, such as acid sulfite (AS), alkali (AL), and alkaline sulfite (ALS), were evaluated using bamboo. Low pressure steam explosion at 1.25 MPa for 4 min was first applied to the bamboo. Then, the pretreated bamboo was delignified using three chemical pretreatments. Enzymatic hydrolysis was also compared among the pretreated bamboo samples. It was found that SE-ALS could be a potential method for bamboo pretreatment, which led to the reduction of lignin from 25.15% to 1.74% at 165 °C for 2 h in 5% (w/v) Na2SO3 and 0.7% (w/v) NaOH; however, little cellulose was solubilized during ALS pretreatment. A maximum glucose yield of 99.35% was achieved during the enzymatic hydrolysis process when combined with the SE-ALS pretreatment. The SE-ALS method resulted in a lower degree of lignin condensation and increased delignification compared to the SE-AS method. In addition, the SE-ALS pretreatment protected carbohydrates from degradation better than the SE-AL methods.

Low-pressure steam explosion (LPSE) combined with alkaline peroxide (AP) pretreatment was first employed to separate hemicellulose from Lespedeza stalks. The monosaccharide composition and molecular weight distribution of the obtained hemicellulose fractions were characterized in this study. The results show that the hemicellulose extracted from Lespedeza stalks consisted of xylose, glucose, galactose, and mannose, which was a mixture of arabinoxylans and xyloglucans or β-glucans. The yield of hemicellulose fractions after AP pretreatment ranged from 11.2% (2.5% hydrogen peroxide (H2O2), w/v for 12 h) to 12.2% (3.3% H2O2, w/v for 72 h). The molecular weight of hemicellulose decreased from 2,458 g/mol to 1,984 g/mol after AP pretreatment, indicating its degradation reaction. The structure of hemicellulose was analyzed by Fourier transform infrared spectroscopy, proton nuclear magnetic resonance, and heteronuclear single quantum coherence. The AP pretreatment partially cleaved the backbone and the ether linkage between lignin and hemicelluloses. Also, branched-chain α-D-arabinofuranosyl in which β-D-xylose substituted at the C-3 position (monosubstituted) was removed, illustrating a partial debranching reaction. Therefore, the combination of low-pressure steam explosion and alkaline peroxide pretreatment (LPSE-AP) is an effective pretreatment method to separate hemicellulose from Lespedeza stalk.

Although biological pretreatment has the advantages of being environmentally friendly and having low-energy consumption, it usually requires a relatively long incubation time. In this study, a novel combined pretreatment with white-rot fungus and alkali at near room-temperature for saccharification of corn stalks was investigated to speed up the biological process. Biological pretreatment with Irpex lacteus or Echinodontium taxodii can improve enzymatic hydrolysis of corn stalk greatly, but the process requires a long time (60 days) to achieve a satisfactory sugar yield. The combination processes with the fungi were compared with the sole pretreatments. The results showed that the time of the biological process could be shortened to 15 days when the bio-treatment with I. lacteus was combined with alkali pretreatment. The efficiency of alkali pretreatment can be also enhanced significantly by biological treatment. 271.1mg/g of final glucose yield was obtained for the combination pretreatment, which was an improvement of 50.4% and 28.3% in comparison with the sole alkali pretreatment at the same and optimum reaction time, respectively. In conclusion, the combination of biological pretreatment with alkali processes not only speeded up the biological process, but also improved the sugar yield in comparison to the sole pretreatment and is favorable for the development of biological pretreatment.

A combination of steam explosion (SE) and alkaline peroxide (AP) used to pretreat bamboo was investigated. Steam explosion at 224 °C for 4 min was applied to bamboo, and the pretreated bamboo was delignified by alkaline peroxide. Enzymatic hydrolysis was compared in the pretreated samples. Steam pretreatment led to remarkable hemicellulose solubilization (63.2%). Lignin solubilization (93.1%) was achieved by alkaline peroxide treatment of steam-pretreated bamboo at 80 °C for 1 h in 0.88% (v/v) H2O2, whereas only 33.4% of lignin was solubilized when using raw bamboo. Pretreatment methods resulted in a low degree of polymerization and increased hydrolysis of cellulose. A maximum glucose yield of 90.5% was achieved with a combined steam explosion and alkaline peroxide pretreatment. The surface structure of treated bamboo and the adsorption of enzyme on the substrate were characterized by X-ray photoelectron spectroscopy. Delignification decreased enzyme adsorption and increased enzymatic conversion. SEM analyses indicated that SE-AP pretreatment disrupted lignin networks and exposed crystalline cellulose in bamboo more effectively than SE or AP pretreatment alone. [ABSTRACT FROM AUTHOR]

Although biological pretreatment has the advantages of being environmentally friendly and having low-energy consumption, it usually requires a relatively long incubation time. In this study, a novel combined pretreatment with white-rot fungus and alkali at near room-temperature for saccharification of corn stalks was investigated to speed up the biological process. Biological pretreatment with Irpex lacteus or Echinodontium taxodii can improve enzymatic hydrolysis of corn stalk greatly, but the process requires a long time (60 days) to achieve a satisfactory sugar yield. The combination processes with the fungi were compared with the sole pretreatments. The results showed that the time of the biological process could be shortened to 15 days when the bio-treatment with I. lacteus was combined with alkali pretreatment. The efficiency of alkali pretreatment can be also enhanced significantly by biological treatment. 271.1mg/g of final glucose yield was obtained for the combination pretreatment, which was an improvement of 50.4% and 28.3% in comparison with the sole alkali pretreatment at the same and optimum reaction time, respectively. In conclusion, the combination of biological pretreatment with alkali processes not only speeded up the biological process, but also improved the sugar yield in comparison to the sole pretreatment and is favorable for the development of biological pretreatment. [ABSTRACT FROM AUTHOR]