Search

Long-term rotary left ventricular assist devices (LVADs) are increasingly employed to bridge patients with end-stage heart failure to transplant or as a destination therapy. Significant recent device development has increased patient support times, shifting further development focus toward physiologically sensitive control of the pump operation. Sensorless control of these devices would benefit from increased observability of the ventricular volume/preload to the pump, in order to regulate flow based on preload, imitating the native Frank-Starling flow control. Monitoring the transmitted flow pulse through the pump has been used as a surrogate for preload, although means of maximizing its transmission are not clear. However, it is known that a flat hydraulic performance curve of the rotary pump induces high changes in flow for a given change in pressure head. The aim of this study was to determine geometric pump parameters responsible for increasing this flow pulse transmission and to demonstrate this increase in vitro. The sensitivity of the performance gradient to blade angles, blade heights, blade clearance, and channel areas were studied. Resulting pressure head, flow, and hydraulic efficiency were analyzed with respect to textbook designed procedures. Then pumps with comparably "flat" and "steep" performance curves were used to simulate LVAD support in vitro over a range of pump flow rates to observe the transmitted flow pulsatility. It was found that an outlet blade angle of 90°, inlet blade angle between 25 and 45°, and large throat area generated a "flatter" performance curve. The transmitted flow pulsatility through a pump with a flat performance curve was 68% higher than that of a steep performance curve at a flow rate of 5 L/min. Substantial gains in the observability of LVAD preload/resident blood volume in the ventricle exist through the careful selection of specific pump geometries.

The use of rotary left ventricular assist devices (LVADs) has extended to destination and recovery therapy for end-stage heart failure. Incidence of right ventricular failure while on LVAD support requires a second device be implanted to support the failing right ventricle. Without a commercially available implantable rotary right ventricular assist device, rotary LVADs are cannulated into the right heart and operation modified to provide suitable support for the pulmonary system. While this approach can alleviate the demand for transplant through long-term biventricular support, it uncovers a new challenge with respect to controller strategies for these dual device support systems. This study compares the preload sensitivity of rotary, dual device biventricular assistance controllers in light of their ability to adjust the flow rate according to physiological demand. A Frank-Starling-like flow controller which requires both inlet pressure and flow sensors is compared to pressure controllers which maintain atrial or inlet cannula pressures through the use of a single pressure sensor. It was found that cannula selection and the location of a pressure controller's single pressure sensor can be tailored to adjust the preload sensitivity. When located within the atria, this sensitivity is effectively infinite. Moving the sensor to the base of a 450-mm cannula, however, decreased the sensitivity to 0.22 (L/min)/mm Hg. This indicates the potential for simple and reliable VAD controllers with increased preload sensitivity without the need for complex controllers requiring an array of hemodynamic sensors.

Clinical studies have reported the balancing of pump outputs to be a serious control issue for rotary biventricular support (BiVS) systems. Poor reliability of long-term, blood immersed pressure sensors encouraged the development of a new control strategy to improve their viability. A rotary BiVS device was designed and constructed with a mechanical passive controller to autoregulate pump outputs to emulate the native baroreceptor response. In vitro testing in a dual circuit, hydraulic mock circulation loop showed that the prototype was able to maintain arterial pressures when subjected to sudden induced hemodynamic destabilization. However, inlet suction was observed when sudden simulated hypertension briefly reduced venous return to the cannulated ventricle. The results have encouraged further development of the device as a means to create an inherently stable, fully passive biventricular support device.