Search

Introduction: Surgical treatment of complex humeral head fractures in the elderly is challenging due to osteoporotic bone, comorbidities and reduced compliance. The treatment strategy (reconstruction versus replacement) should allow for a functional aftercare and result in a high patient satisfaction. Major complications leading to surgical revision are crucial and should be avoided. The purpose of this study was to analyse the major complication rate leading to surgical revision and the patient-based outcome in complex humeral head fractures of the elderly population treated either using locking plate fixation (LCP) or reversed total shoulder arthroplasty (rTSA)., Materials and Methods: All patients older than 65 years surgically treated due to a four-part fracture of the proximal humerus between 2003 and 2015 were enrolled in our retrospective study. Major complications and revision rates were recorded and functional outcome was assessed using the Munich Shoulder Questionnaire (MSQ) allowing for qualitative self-assessment of the Shoulder Pain and Disability Index (SPADI), of the Disability of the Arm, Shoulder and Hand (DASH) score and of the Constant Score., Results: A cohort of 103 patients with a mean age of 73.4 ± 6.2 years suffering from four-part fractures of the humeral head were enrolled. 63 patients were treated using the LCP fixation compared to 40 rTSAs. There were no significant differences in the patient-reported functional outcome. The revision rate was significantly higher in the LCP group (10/63; 15.9%) compared to the rTSA group (1/40; 2.5%). Reasons for revision were avascular head necrosis, cut-out of screws, secondary dislocation of the greater tuberosity and hypersensitivity to metal., Conclusions: Reversed total shoulder arthroplasty and locking plate fixation are both established surgical procedures for the management of complex proximal humerus fractures in the elderly leading to similar functional results. However the revision rate in the rTSA group was significantly lower. Primary rTSA should, therefore, be favoured in multimorbid elderly patients with an increased complication risk to avoid repeated anaesthesia., (© 2021. The Author(s).)

Background: Elective implant removal (IR) accounts for up to 30% of all orthopaedic surgeries. While there is general acceptance about the need of implant removal for obvious reasons, such as infections or implant failure, little is known about the beneficial aspects in cases of minor reasons such as patients' wish for IR. Therefore, we initiated this study to define patients' benefit of elective implant removal following plate osteosynthesis of displaced clavicle fractures., Patients and Methods: Prospective evaluation of patients was conducted before implant removal and 6 weeks postoperative. Subjective and objective criteria included pain rating on a visual analogue scale (VAS) and active range of motion (ROM) pre- and 6 weeks postoperative. Functional scoring included Constant-Murley Score, DASH (Disabilities of Arm, Shoulder and Hand Score), MSQ (Munich Shoulder Questionnaire) and SPADI (Shoulder Pain and Disability Index)., Results: 37 patients were prospectively enrolled in this study and implant removal was performed after 16 ± 6.1 months. No re-fractures nor other complications were detected during routine follow up. Functional outcome increased through all scores (Constant score 73.3 ± 14.6 preoperative to 87.4 ± 12.0 postoperative (p = 0.000), MSQ 85.0 ± 7.3 preoperative to 91.8 ± 9.0 postoperative (p = 0.005), DASH Score 7.4 ± 8.2 preoperative to 5.7 ± 9.5 postoperative (p = 0.414), SPADI 93.4 ± 6.6 preoperative to 94.0 ± 10.1 postoperative (p = 0.734)., Conclusions: Discomfort during daily activities or performing sports as well as limited range of motion were the main reasons for patients' wish for implant removal. We found increased functional outcome parameters and decreased irritation after implant removal. Therefore we suggest implant removal in case of patients' wish and completed fracture consolidation., Trial Registration: Trial registration no: NCT04343118, Retrospective registered: www.clinicaltrials.gov ., (© 2020. The Author(s).)

Introduction: For comminuted and displaced fractures of the radial head open reduction and internal fixation (ORIF) is recommended nowadays as the treatment of choice. Due to the development of locking plates the possibilities of ORIF in complex fracture types were extended. The purpose of this retrospective survey therefore was to review the preliminary subjective and objective results in patients treated by anatomically preshaped locked plating. A reliable fracture healing for these recently introduced plating devices was hypothesized., Materials and Methods: Subjective and objective criteria included patient's satisfaction, pain rating on a visual analogue scale (VAS) and active range of motion (ROM) compared to the contralateral armside. Functional scoring included the Morrey elbow performance score (MEPS), the QuickDASH and the elbow self-assessment score (ESAS). Furthermore, follow-up radiographs were reviewed., Results: Between 2011 and 2014 a total of 24 patients were managed with ORIF using anatomically preshaped low-profile locking plates. All patients had suffered from comminuted radial head fractures (type III-IV according to Mason classification). Twenty of 24 patients returned for follow-up examination after a mean of 30 months (range 18-53 months). Patients' satisfaction was rated as highly satisfied in 17 cases and satisfied in 3 cases. An unrestricted ROM for extension-flexion arc and pronation-supination arc was rated in 10 cases. Minor ROM deficiencies with a 5° limited extension compared to the contralateral side was evaluated in 6 cases. Only four patients were rated with and extension and supination deficiency of 10°, one of whom with an additional pronation deficiency of 10°. The calculated MEPS was Ø 98 ± 4 (range 85-100), and the QuickDASH was Ø 3 ± 6 (range 0-21). The ESAS was completed by 18 patients with a mean of Ø 96.54 ± 2.95 (range 94-100) indicating a non-restricted elbow function., Conclusions: The treatment of comminuted radial head fractures using anatomically preshaped locking radial head plates represents a reliable and safe surgical approach, leading to good to excellent functional results. Being aware of the importance of the radial head for elbow stability, open reduction and internal fixation should be preferred prior to radial head resection or replacement in complex radial head fractures. Further trials with a higher number of patients are needed to confirm the advantages of preshaped radial head plates.

Introduction: Osteoporosis is a highly focused issue in current scientific research and clinical treatment. Especially in rotator cuff repair, the low bone quality of patients suffering from osteoporosis is an important issue. In this context, non-biological solutions using PMMA for anchor augmentation have been developed in the recent past. The aim of this study was to evaluate whether augmentation of suture anchors using bio-absorbable osteoconductive fiber-reinforced calcium phosphate results in improved failure load of suture anchors as well., Materials and Methods: Altogether 24 suture anchors (Corkscrew FT 1 Suture Anchors, Arthrex, Naples, FL, USA) were evaluated by applying traction until pullout in 12 paired fresh frozen human cadaver humeri using a servo-hydraulic testing machine. Inclusion criteria were an age of more than 64 years, a macroscopically intact RC and an intact bone. The anchors were evaluated at the anterolateral and posteromedial aspect of the greater tuberosity. 12 suture anchors were augmented and 12 suture anchors were conventionally inserted., Results: The failure load was significantly enhanced by 66.8 % by the augmentation method. The fiber-reinforced calcium phosphate could be easily injected and applied., Conclusion: The bio-absorbable cement in this study could be a promising augmentation material for RC reconstructions, but further research is necessary-the material has to be evaluated in vivo.

Purpose: The presented biomechanical study focused on the in vitro analysis of tractile forces working on the anterior cruciate ligament (ACL) and the ACL transplants, respectively, using a semitendinosus and/or patellar tendon during a passive flexion-extension movement (150-0°)., Material and Methods: Overall, 15 fresh frozen human knee joint pairs were examined. At first during arthroscopy, the tibial insertion of the ACL was drilled using a special hollow drill. Thereby, a bone cylinder was exposed at which a dynamometer was attached to enable for direct registration of tractile forces on the ACL via the connection between ACL-dynamometer and computer. The ACL transplant was fixed at the femur using a so-called endo-button, whereas the dynamometer was attached to the tibial end of the ACL transplant. The dynamic part of the examination was performed using the knee kinemator device developed by Plitz and Wirth et al. using different preload., Results: The curves of the tractile forces of the ACL were qualitatively homogeneous with only low force values in the middle flexion position, whereas during maximum flexion and extension the forces increased reaching a maximum in the 0° position. Also, in testing the ACL transplants a force decrease between 0 and 50° flexion was recognized with even greater forces resulting at the 150° position depending on the anterior position of the femoral drill channel for implanting the ACL transplant. The amount of pre-loading showed no influence on the form of the tractile force curve. However, by enhancing the preload to 70 N, the maximal force in the ACL transplant increased significantly., Conclusion: The tractile forces assessed within the ACL during passive flexion movements between 10 and 90° were not greater than the forces measured in the ACL transplants. Thus, the clinical consequence is that in the early postoperative phase passive mobilization might be performed in this motion range without putting the ACL transplant at risk for damage.

Purpose: Rotator cuff (RC) repair-especially in the elderly population-is problematic since the patients suffer to a high extent from bone mineral density loss at the reattachment site. Therefore, the study was primarily driven by the question whether it is possible to reach more or qualitatively better cancellous bone and thus a more stable postoperative result if anchors with greater length are used for RC repair and/or the conventional anchors are screwed deeper into the bone. In anatomical terms, the question is raised whether cancellous bone is of better quality close to or far off the RC enthesis., Methods: Axial HRqCT scans (X-tremeCT, Scanco Medical) of 36 human cadaveric humeral heads (75 ± 11 years) were performed to determine the ratio of bone volume to total volume (BV/TV), trabecular thickness (Trab Th), number of trabecles (Trab N), trabecular separation (Trab Sp) as well as non-metric indices such as connectivity density (Conn Dens) and structure model index (SMI). Within the greater tuberosity (GT), 6 volumes of interest (VOI) (A1, B1, C1, A2, B2, C2), in the lesser tuberosity (LT) 2 VOIs (D1, D2) and one control VOI in the subchondral bone were set. The analyzed bone cylinder of each VOI was divided into a superficial and a deep portion., Results: The parameters BV/TV, Trab N, Trab Th and Conn Dens in all volumes of the GT and LT revealed higher values in the superficial portion reaching different levels of significance (p < 0.001/<0.05). The only parameter presenting a higher value in the deep portion was Trab Sp, but this was the case for all GT and LT regions. Interestingly, the difference between the superficial and deep portion reached significance for the non-metric parameter SMI in no volume of the GT/LT, although the higher values were found superficially., Conclusions: Our data show that cancellous bone presents with decreasing bone quality when analyzing increasingly deeper portions of the bone cylinders of the GT and LT starting at the articular surface. This information seems to be crucial for shoulder surgeons, especially when treating elderly patients. Our results clearly prove that screwing in anchors to a deeper extent will not improve stability, since the deeper bone stock is of worse quality.

Tears of the rotator cuff (RC) complicated by bone cysts at the footprint might represent a challenge for the shoulder surgeon. This might be additionally aggravated in elderly patients with inferior bone quality due to osteopenia or osteoporosis. In this report we present a technique for open repair of RC tears by augmenting the cystic lesion at the greater tuberosity using bone void filler in combination with a double row anchor reconstruction technique. Despite disadvantageous position and size of the cyst, using this technique the footprint can be restored by obtaining an anatomical position of the supraspinatus tendon. The application range of this technique is not limited to defined bony defects and presents a promising novel surgical approach. Level of evidence V.