Search

This paper presents the findings of fatigue strength tests of 15CrNi6 steel following low-pressure carburizing and oil quenching, subjected to cycles of one-sided three-point bending. The fatigue fractures were compared with the results of fatigue strength studies of 16MnCr5 steel following low-pressure carburizing and nitrogen quenching. The fatigue tests for 16MnCr5 steel were conducted as part of a high-cycle resonance test, with a pendular bending load. The study also involved an analysis of the effects on non-metallic inclusions in the structure on the mechanism of fatigue destruction. The inclusions were found to initiate fatigue cracks. In both cases, a similar method of a fatigue fissure initiation was observed, independent of the study method or specimen material. [ABSTRACT FROM AUTHOR]

This paper presents a comparison of the deformations and residual stresses in gear wheels after vacuum carburizing process with quenching in high-pressure nitrogen and oil. The comparison was made on a medium-sized gear wheels, made of AMS6265 (AISI 9310) steel. This steel is applied in the aerospace industry for gears. The study has provided grounds for an assessment of the effect of the method of quenching on the size of deformations. Compared to oil quenching, high-pressure gas quenching following vacuum carburizing resulted in more uniform and smaller deformations. [ABSTRACT FROM AUTHOR]

Abrasive blasting is one of the methods of surface working before hot-dip zinc-coating. It allows not only to remove products of corrosion from the surface, but it also affects the quality of the zinc coating applied later, thereby affecting wettability of surface being zinc-coated. The surface working can be done with different types of abrasive material. The paper presents an effect of the method of abrasive blasting on wetting the surface of steel sheets by liquid zinc. Steels sheets following blasting with Al2O3 of different granularity and shot peening were examined. The worst wetting was recorded for a sample following shot peening - the results are below those for the reference test conducted for a sample not previously subjected to any treatment. Samples following abrasive blasting have similar parameters, regardless of the size of grain used for the treatment. [ABSTRACT FROM AUTHOR]