Search

Sea trials to test size selectivity equipment in trawls are often limited in time because they are costly, and the results can be influenced by multiple factors that are often overlooked. In the Barents Sea gadoid trawl fishery, the use of a size sorting grid in front of the codend is compulsory. The flexigrid, a netting section containing two flexible grids, is the most widely used grid section in this fishery. However, earlier selectivity studies with this device have shown inconclusive results. It has been speculated that the differences observed resulted from the difference in age and usage of the grid sections in the studies compared. To reveal whether potential changes in the device construction over time can lead to differences in size selection properties, we performed comparative fishing trials where we compared a brand new flexigrid section and a well-used flexigrid section used continuously by a commercial trawler for approximately four years. The results showed that the new flexigrid released significantly more cod below ∼60 cm than the used flexigrid. However, when the grids were fished with a subsequent diamond mesh codend, there was no difference in the overall selectivity of the two gears, meaning that the size selectivity in the codend compensates for the potential reduction in selectivity performance of the grids. This study shows the importance of considering the age and earlier use of size selection devices like sorting grids before they are compared with other devices, as their size selection properties can change significantly over time and with use.

The offshore Northern shrimp (Pandalus borealis) bottom trawl fishery in eastern Canada currently uses 22 and 28 mm bar spacing Nordmøre grids to limit bycatch from using small mesh codends. However, a recent rebound of juvenile redfish (Sebastes spp.), that can pass through the grids, has greatly increased bycatch. To address this concern, this study investigated the effectiveness of 17 and 15 mm bar spacing Nordmøre grids in a twin-trawl (paired) configuration against the traditional 22 mm bar spacing grid. Size selectivity analyses showed that the 17 and 15 mm grids resulted in no significant reduction in shrimp catch across all length classes. The 17 mm grid significantly reduced redfish bycatch for all length classes and the 15 mm grid significantly reduced redfish bycatch for individuals larger than 95 mm total length. Less redfish entered the codend with the experimental grids, however, the overlap in width between redfish and Northern shrimp limits the overall sorting efficiency of the grids, leaving some redfish still vulnerable to capture.

The size selectivity and catch pattern of Trichiurus lepturus in 40 mm diamond and square mesh codends were investigated in this study. A 34 m high opening trawl was used, which is a common design used by fishermen operating along the northwest coast of India, and the cover codend method was employed to determine codend selectivity. Along with the changes in the length at 50% retention rate for Trichiurus lepturus with the usage of the square and diamond mesh codends, indicators to understand the exploitation pattern of this species in the fishery were assessed based on the total number of individuals and on total weight of the catch. The mean selection length increased and discard fraction is reduced when 40 mm square mesh codends are used in place of diamond meshes, however, it is observed that individuals at commercial length are also lost. The results demonstrate that mandatory use of legal mesh sizes alone will be insufficient to aid in the sustainable harvest of this species, given its estimated length at first sexual maturity of 61.2 cm. This is the first study to compare the size selection of this species in 40 mm diamond and square mesh codends along Northwest coast of India. Results of the study will help as a baseline for gear-based regulations in the region.

The size selectivity and usability of three codends were quantified and compared for the first time in the inshore Northern shrimp (Pandalus borealis) trawl fishery of Iceland using the covered codend method: a conventional diamond-mesh codend (T0), conventional square-mesh codend (T45), and a 90° turned mesh codend (T90) constructed of four panels and with shortened lastridge ropes. Fishers, wanting to increase the average-individual size of captured shrimp, had requested the T90 codend to be compared with conventional codends for consideration in the fishery. Results showed that, on average, the T45 and T90 codends had better size selectivity than the T0 codend in terms of releasing individuals smaller than 13 mm carapace length (Minimum References Size; MRS). The T90 codend retained significantly less Northern shrimps between 9 and 19 mm than the T0 codend and between 15 and 19 mm than the T45 codend. No significant difference of size selectivity between T45 and T0 codends was observed. All three codends presented high retention ratios of Northern shrimps above MRS (>63%) for the population encountered. However, the T0 codend was not effective at sorting out small Northern shrimps; at least 86% of Northern shrimps smaller than 13 mm were retained in the T0 codend if encountered. Catches from T45 and T90 codends had a lower proportion of shrimp below MRS. Since discarding of undersized Northern shrimps is prohibited in Iceland and fishers wanted to catch on average larger shrimp, using the novel T90 codend would enable fishers to use their quotas more efficiently.