Search

Adhesive wear is one of the major reasons for the failure of components during various tribological application, especially for rubbing with viscous materials. This study presents CrN/DLC/Cr-DLC multilayer composite coatings prepared on a plasma enhanced chemical vapor deposition (PECVD) device with the close field unbalanced magnetron sputtering ion plating (CFUBMSIP) technique. SEM, XRD and Raman spectroscopy were used to determine the structure of multilayer coatings. It was found that the multilayer coatings are composed by the alternating CrN and DLC layers. Compared with the single CrN coatings, the friction coefficient of the CrN/DLC/Cr-DLC multilayer coating decreases about more than seven times after sliding a distance of 500 m. This helps to reduce the adhesive wear of multilayer coatings. Compared with the single CrN and DLC coating, the wear rate of the CrN/DLC/Cr-DLC multilayer coating is reduced by an order of magnitude to 7.10 × 10 −17 (sliding with AISI 440C) and 2.64 × 10 −17 (sliding with TC4) m 3 /(N m). The improved tribological performance of multilayer coatings mainly attributes to the introduction of lubricant DLC and hard support CrN layers, the enhancement of crack propagation inhibition, and the increment of elastic recovery value W e (71.49%) by multilayer design method. [ABSTRACT FROM AUTHOR]

[Display omitted] • The (CrAlTiNbV)N x high-entropy coatings are prepared by magnetron sputtering method. • All coatings exhibit columnar growth morphology and own a single FCC structure. • The S-38 owns a friction coefficient of 0.096 and wear rate of 1.8 × 10−7 mm3/(N·m). • The excellent wear resistance of S-38 is mainly attributed to its dense structure. (CrAlTiNbV)N x high-entropy nitride coatings are deposited via tuning nitrogen flow rates, and evaluating their influence on the microstructure, mechanical and tribological properties of the coatings. All deposited coatings exhibit columnar growth morphology and own a single face-center-cubic structure. As the nitrogen flow rate increases, the preferred orientation of the coating gradually transfers from (1 1 1) to (2 0 0) and (2 2 0), and then changes back to (1 1 1) with the nitrogen flow rate continues to increase. The S-38 sample possesses the optimal plastic deformation resistance and adhesion strength. Friction and wear results show that the (CrAlTiNbV)N x coating deposited at nitrogen flow rate of 38 sccm owns the best tribological properties with a friction coefficient of 0.096 and wear rate of 1.8 × 10−7 mm3/(N·m) in 4050# aviation oil. [ABSTRACT FROM AUTHOR]