Search

As the penetration of renewable energy increases, the distribution grid faces great challenges in integrating large amounts of distributed energy sources and dealing with their output uncertainty. To address this, a multi-time scale optimal dispatch method based on model predictive control is proposed, including a day-ahead stage and an intra-day rolling stage. In the day-ahead stage, to fully utilize the flexibility of variable speed pumped storage hydropower, the generating/pumping phase modulation condition is considered, not just generating or pumping. Day-ahead optimal dispatch is established with the objective of minimizing the operation economy and node voltage deviation of the distribution network. In the intra-day rolling stage, model predictive control with finite time domain rolling optimal dispatch is used to replace the traditional single-time section optimal dispatch, considering the forecast data of wind, photovoltaic (PV), and load within the finite time domain, so that can respond in advance to smooth the generator output. At the same time, the uncertainty problem of the distribution network is solved effectively by rolling optimization and feedback correction of model predictive control. In order to consider the daily operating capacity balance of energy storage in the intra-day stage, the capacity imbalance penalty is added to the intra-day rolling optimization objective function, so that the energy storage capacity tries to track the results of the day-ahead optimization, achieving the long-term development of energy storage. Simulation analysis proves the feasibility and effectiveness of the proposed method. The proposed method enhances the generation–load–storage coordinated dispatching ability, effectively improving the distribution network's capability to respond to fluctuations of renewable energy. [ABSTRACT FROM AUTHOR]

As the penetration rate of clean energy gradually increases, the demand for flexible regulation resources in the power grid is increasing accordingly. The variable-speed pumped storage unit with a full-size converter (FSC-VSPSU) can provide fast and flexible regulation resources for the power grid, which assists in the stable operation of the clean-energy-dominated power systems. Thus, its application is gradually becoming widespread. FSC-VSPSU relies on the power electronic converter for grid connection. When the impedance mismatch between FSC-VSPSU and the power grid occurs, the grid-connected system will experience oscillations, which seriously threatens its safe and stable operation. Aiming at this, this article firstly relies on the SISO impedance measurement and an equivalent impedance analysis to obtain the stability analysis criterion. Furthermore, applying the impedance matching analysis with the Bode diagram, the influence rules of the parameters of the grid-connected FSC-VSPSU on oscillation are obtained. In addition, with the summarized oscillation analysis results, this study delves into an exploration of pertinent strategies for oscillation suppression. Finally, a grid-connected FSC-VSPSU simulation model is built in MATLAB/SIMULINK, and the simulation results verify the correctness of the oscillation analysis results and the effectiveness of the proposed oscillation suppression strategy. [ABSTRACT FROM AUTHOR]

Fault ride-through is a prerequisite for ensuring continuous operation of a variable-speed pumped storage unit with a full-size converter (FSC-VSPU) and providing support for the renewable energy and power grid. This paper proposes low-voltage ride through (LVRT) and high-voltage ride through (HVRT) strategies for FSC-VSPU to address this issue. Firstly, the structure of FSC-VSPU and its control strategy under power generation and pumping conditions are described. Subsequently, the fault characteristics of the FSC-VSPU under different operating conditions are analyzed. More stringent fault ride-through technical requirements than those for wind turbines are proposed. On this basis, the fault ride-through strategies of combining fast power drop, rotor energy storage control, power anti-regulation control, dynamic reactive current control, low power protection, and DC crowbar circuit are proposed. Simulation case studies conducted in PSCAD/EMTDC verify the correctness of the theoretical analysis and the effectiveness of the LVRT and HVRT strategies in this paper. [ABSTRACT FROM AUTHOR]

Subsynchronous oscillation (SSO) is the resonance between a new energy generator set and a weak power grid, and the resonance frequency is usually the sub-/super-synchronous frequency. The eigensystem realization algorithm (ERA) is a classic algorithm for extracting modal parameters based on matrix decomposition. By leveraging the ERA's simplicity and low computational cost, an enhanced methodology for identifying the key parameters of SSO is introduced. The enhanced algorithm realizes SSO angular frequency extraction by constructing an angular frequency fitting equation, enabling efficient identification of SSO parameters using only a 200 ms synchrophasor sequence. In the process of identification, the fitting-based ERA effectively addresses the limitation of the existing ERA. The accuracy of SSO parameter identification is improved, thereby realizing that SSO parameter identification can be carried out using a 200 ms data window. The fitting-based ERA is verified using synthetic and actual data from synchrophasor measurement terminals. The research results show that the proposed algorithm can accurately extract fundamental and subsynchronous or supersynchronous oscillation parameters, effectively realizing dynamic real-time monitoring of subsynchronous oscillations. [ABSTRACT FROM AUTHOR]

Aiming at the problem of ultra-low-frequency oscillation (ULFO) in power systems, with an oscillation frequency lower than 0.1 Hz, an oscillation suppression control method is proposed. Firstly, the mathematical modeling of the system is carried out, and a cascade correction control method of the governor of hydropower generators is proposed. Secondly, using the ability of photovoltaic (PV) active power to adjust the system frequency, an additional controller for PV active power is proposed. Then, a unified frequency model considering the two controllers is established for multi-hydro and multi-PV systems, and the structural singular value method is used to coordinate the design of the parameters of the hydropower and PV generator controllers to achieve robust performance. Finally, based on a time-domain simulation of single-hydro and single-PV systems and an actual demonstration system located in Sichuan Province, China, the results show that the control method proposed in this paper has a good suppression effect on ultra-low-frequency oscillation under different working conditions, and meets the requirements of robust performance. [ABSTRACT FROM AUTHOR]