Search

Featured Application: Numerical results to determine the fire resistance of ultra-high-strength steel using different heating rates. Ultra-High-Strength Steel (UHSS) offers several advantages over normal carbon steel, promoting exceptional strength, reducing self-weight, improving fire resistance, enhancing durability, and reducing material consumption. These advantages result in cost savings and sustainable engineering construction. The 3D numerical model is based on Geometrical and Materially Nonlinear Imperfection Analysis (GMNIA) and determines the fire resistance of different cross-section columns. The model is validated with experimental tests, with a maximum relative error of 11%. A parametric analysis is presented, based on 252 simulations, assuming three heating rates, two different cross-sections, two different thicknesses, three lengths, and seven load levels. The fire resistance depends on the heating rate, but the critical temperature is almost equal and independent of the heating rate, if one assumes implicit creep in the constitutive material model. The fire resistance decreases with the load level, as expected. The thickness effect of the hollow section is almost negligible in the fire resistance of UHSS columns. The fire resistance decreases more in higher load levels for slender columns. Columns with Circular Hollow Sections (CHSs) generally show higher fire resistance than hybrid columns in longer columns, but the hybrid columns are subject to much higher loads. New design formulas are presented for the critical temperature of UHSS columns, depending on the load level and slenderness of two different cross-sections. [ABSTRACT FROM AUTHOR]

Metal machining is one of the most important manufacturing processes in today's production sector. The tools used in machining have been developed over the years to improve their performance, by reducing the cutting forces, the friction coefficient, and the heat generated during the cutting process. Several cooling systems have emerged as an effective way to remove the excessive heat generated from the chip-tool contact region. In recent years, the introduction of nano and micro-textures on the surface of tools has allowed to further improve their overall performance. However, there is not sufficient scientific data to clearly show how surface texturing can contribute to the reduction of tool temperature and identify its mechanisms. Therefore, this work proposes an experimental setup to study the tool surface characteristics' impact on the heat transfer rate from the tools' surface to the cooling fluid. Firstly, a numerical model is developed to mimic the heat energy flow from the tool. Next, the design variables were adjusted to get a linear system response and to achieve a fast steady-state thermal condition. Finally, the experimental device was implemented based on the optimized numerical model. A good agreement was obtained between the experimental tests and numerical simulations, validating the concept and the implementation of the experimental setup. A square grid pattern of 100 μm × 100 μm with grooves depths of 50, 100, and 150 μm was introduced on cutting insert surfaces by laser ablation. The experimental results show that there is a linear increase in heat transfer rate with the depth of the grooves relatively to a standard surface, with an increase of 3.77% for the depth of 150 μm. This is associated with the increase of the contact area with the coolant, the generation of greater fluid turbulence near the surface, and the enhancement of the surface wettability. [ABSTRACT FROM AUTHOR]