Search

L10 FePtC granular media are being studied as potential future magnetic recording media and are set to be used in conjunction with heat assisted magnetic recording (HAMR) to enable recording at write fields within the range of current day recording heads. Media structures based on a FePtC storage layer and a capping layer can alleviate the switching field distribution (SFD) requirements of HAMR and reduce the noise originating from the writing process. However, the current designs suffer from SFD issues due to high temperature writing. To overcome this problem, we study a CoPt/FePtC exchange coupled composite structure, where FePtC serves as the storage layer and CoPt (with higher Curie temperature, Tc) as the capping layer. CoPt remains ferromagnetic at near Tc of FePtC. Consequently, the counter exchange energy from CoPt would reduce the noise resulting from the adjacent grain interactions during the writing process. CoPt/FePtC bilayer samples with different thicknesses of CoPt were investigated. Our studies found that CoPt forms a continuous layer at a thickness of 6 nm and leads to considerable reduction in the saturation field and its distribution. ASTAR (Agency for Sci., Tech. and Research, S’pore) Published version

Nano-patterning on the order of sub-10 nm is integral to achieve high-density nano-scale devices for various data storage and data processing applications. However, the additional requirement of planarization and unwanted side-effects of physical or chemical etching have so far limited the patterning of sub-10 nm devices. In this work, we have demonstrated the creation of an array of ∼10 nm ferromagnetic islands through selective phase transformation of paramagnetic multilayers by low-energy proton irradiation. Paramagnetic Co3O4/Pd multilayers masked with patterned PMMA (polymethyl methacrylate) were reduced to ferromagnetic Co/Pd by proton irradiation. A clear contrast of the nano-islands was observed using magnetic force microscopy, establishing the formation of ferromagnetic nano-islands with perpendicular magnetic anisotropy. This process provides a way to circumvent the side-effects associated with both conventional nano-scale pattering and high-energy ion irradiation. Therefore, phase transformatio...

Satisfying the mutually conflicting requirements of easy switchability and high thermal stability still remains a hindrance to achieving ultra-high areal densities in hard disk drives. Exchange coupled composite media used with proper exchange control layers (ECLs) presents a potential solution to circumvent this hindrance. In this work, we have studied the role of MgO and Ta ECLs of different thicknesses in reducing the switching field of FePt media. MgO ECL was found to be more effective than a Ta ECL. For a 2 nm MgO ECL, the switching field could be reduced by 41% and at the cost of only a limited loss in thermal stability. Furthermore, a very high switching efficiency of 1.9 was obtained using 2 nm MgO ECL. So, with a proper choice of ECL material and thickness, the switching field of FePt media can be substantially reduced while ensuring high thermal stability and a better signal-to-noise ratio, thus potentially paving the way for very high areal density media. NRF (Natl Research Foundation, S’pore) ASTAR (Agency for Sci., Tech. and Research, S’pore) Published version

We describe measurements of the stiffness and Young’s modulus, Y of single crystals of molybdenum-based compounds. Atomic force microscopy is used first to image, and then to perform stiffness measurements on crystals which are growing up out of a substrate. Y is extracted by comparing the measured stiffness with that calculated from a continuum elasticity model of the crystals, whose experimentally indeterminate parameters are the Young’s modulus and the geometry. We find a value for Y in the range 0.8–1.4 TPa, depending on the assumed geometry of the nanocrystal. As these crystals are essentially perfectly ordered on the micron scale, this opens the possibility of forming composite materials of immense strength.