Search

Nowadays, microstructures have an important role in optical products as well as in optical systems. Beside machining methods, hot glass embossing is recently a novel technology to manufacture microstructures in optical components with high quality and low cost. Especially, this technology has been assisted efficiently by ultrasonic vibration. Previous studies showed that high energy of ultrasonic vibration would lead to the temperature rise inside the glass so that the material was easily embossed into the microcavities on the mold. Thus, micro-formability of glass material has been especially improved efficiently. However, there were no studies focusing on effect of ultrasonic vibration on embossing speed in this process. Therefore, this work is aimed to utilize ultrasonic vibration to improve the embossing speed of hot glass embossing process. K-PSK100 optical glass was used as the material for all experiments. Pyramid array with size of 30 × 30 × 20 μm and period of 150 μm was created on the mold. Microstructure hot embossing experiments were conducted for both conventional process (without ultrasonic vibration) and ultrasonic vibration-assisted process (frequency of 35 kHz and amplitude of 3 μm). By fixing the embossing temperature of 430 °C, the embossing speeds of 0.05 mm/min, 0.10 mm/min and 0.15 mm/min were applied, respectively. Experimental results showed that in case of conventional process, the faster embossing speed, the smaller final height of pyramid structures. Nevertheless, this obstacle was resolved by ultrasonic vibration. Under heating effect of ultrasonic vibration, the glass still filled well into the pyramid cavities on the mold even when the high embossing speed was applied. Measurements indicated that in the same experimental conditions (temperature and speed), ultrasonic vibration could improve the filling ability of the glass to 18 %. This finding could be used to optimize the experimental conditions to increase the productivity of the microstructure hot glass embossing process.

The aim of this research is to investigate numerically the neck-spinning process of a tube at elevated temperature. The commercial software Abaqus/Explicit was adopted in the simulation. For the construction of the material model, special uni-axial tensile tests were conducted at elevated temperature and various strain rates, since the material is sensitive to strain rates at high temperature. The influence of the element type and mass scaling factor were investigated through numerical simulation. Full-integration shell element is the better choice in the simulation of the neck-spinning process at elevated temperature. The use of suitable mass scaling factor will make the analysis more efficiency. Comparisons between experimental and simulation results on thickness distribution and the outer contour of the spun tube are discussed. Good agreement was found between experimental and simulation results.

This research integrated finite element analysis (FEA) and optimum design to obtain a fast, accurate and automatic optimization system for the design of an ultrasonic horn. The optimization system was developed to achieve uniform amplitude distribution on the output surface of a block shaped horn for the ultrasonic plastic welding. Agreement between the experimental and numerical data proved that this optimization system was efficient in the design of ultrasonic horns.