Search

A new combustion system has been applied to a 300 MW e down-fired boiler with swirl burners to reduce NO x emissions. The unit provided the introduction of overfire air (OFA) and a decrease in the flow area of the inner and outer secondary air ducts of the swirl burners. Industrial experiments on the retrofitted boiler were performed at different loads. Full-scale measurements of the flue gas temperature distribution in the burner outlet region, the furnace temperature distributions measured by a pyrometer and the local mean gas species concentrations in the region near the sidewall were made at loads of 180, 250, and 300 MW e . The results show that the ignition distance increased with decreasing load, especially as the load decreased from 250 MW e to 180 MW e . At three different loads, the retrofitted coal/air flow could be all ignited in time at a distance in the range of 0.6–1.4 m from the burner outlet. Compared with the original combustion system, the ignition distance of the coal/air flow was significantly reduced at a load of 300 MW e . In addition, at a load of 300 MW e , the temperature of the boiler hopper was much higher than that at loads of 180 MW e and 250 MW e . Compared with the original combustion system, the upper furnace temperature decreased slowly with increasing measurement height at a load of 300 MW e after the retrofit. Measurements of the O 2 and CO concentrations in the region near the sidewall indicate that the fullness degree of the coal flame in the furnace at different loads was different. After the retrofit, the reheat steam temperatures reached the design temperature of 541 °C at loads of 180 MW e and 250 MW e , and the average reheat steam temperatures increased by approximately 13 °C. Compared with the original combustion system, a significant NO x reduction (more than 40%) at different loads was achieved without increasing the levels of unburnt carbon in the fly ash. [ABSTRACT FROM AUTHOR]

To achieve significant reductions in NO x emissions without increasing the levels of unburnt carbon in the fly ash, a new combustion system was applied to a 300-MW e Babcock & Wilcox (B&W) down-fired boiler installed with swirl burners. The unit featured introduced overfire air (OFA) and decreased outlet area of the inner and outer secondary-air ducts of the swirl burners. Full-scale measurements (adjusting the inner secondary-air vane angle to 35°, 45°, and 55°) revealed that the influence of the high-temperature recirculating region under the arch upon the combustion and NO x emission characteristics of the boiler is greater than that of the high-temperature flue gas entrained by the swirl burner itself. The ignition distance of the coal/air flow is reduced by at least 1.8 m compared with that of the original combustion system. For the inner secondary-air vane angle of 35°, the coal/air flow ignites earlier than for the vane angles of 45° and 55°. The measurements of the gas species concentrations in the zone near the sidewall indicates that at inspection port 1, the coal flame of the burners does not spread across the entire furnace cross-section for all three vane angles; however, for the vane angle of 35° the flame is spread across the entire furnace cross-section at inspection port 2. For this optimal (35°) inner secondary-air vane angle, the NO x emissions and carbon content in the fly ash reached levels of 674 mg/m 3 (6% O 2 ), and 11.4%, respectively, achieving a significant NO x reduction of 51.9% without increasing the levels of unburnt carbon in the fly ash. [ABSTRACT FROM AUTHOR]