Search

A 300-MW e anthracite and down-fired boiler equipped with swirl burners, which was retrofitted with the previously proposed deep-air-staging combustion technology to reduce particularly high NO x emissions, still suffered from high carbon content in fly ash (despite this content being slightly lower than that before retrofit) on basis of significant NO x reduction. To comprehensively produce a high-burnout and low-NO x setting, a novel combustion technology was proposed in which relative to the axis of the primary air duct, the axes of the inner and outer secondary air ducts of the swirl burner shift away from the furnace center, and this technology is called an eccentric-swirl-secondary-air combustion technology. The coaxial symmetrical arrangements of primary and secondary air ducts for traditional swirl burners are broken. Full-scale industrial measurements under original, deep-air-staging and eccentric-swirl-secondary-air combustion technologies with respect to different loads (i.e., 180, 250, and 300 MW e ) were carried out to compare and analyze the validity of and improvement offered by the eccentric-swirl-secondary-air combustion technology. Under different boiler loads, especially at low and middle loads, compared with original and deep-air-staging combustion technologies, eccentric-swirl-secondary-air combustion technology markedly extends the penetration depth of coal/air flow and recirculation regions below arches. The thermal resistance between primary coal/air flow and high-temperature flue gas at the furnace center is reduced further, and the ignition of pulverized coal is timelier. The heating gradient in the burner outlet zone is maintained throughout, and the flame fullness in the primary combustion zone increases. The above three aspects contribute to pulverized coal burnout. Similar to deep-air-staging combustion technology, a low-oxygen and strong reducing atmosphere was formed in the primary combustion zone to reduce NO x formation due to the introduction of overfire air. Compared with deep-air-staging combustion technology, for the eccentric-swirl-secondary-air combustion technology, the air staged combustion in the furnace is improved further, and pulverized coal combustion in the primary combustion zone is more well distributed, which is beneficial to further reducing NO x emissions. The results of low-NO x and high-efficiency performance show that compared with the original boiler, NO x emissions and carbon content in fly ash for the boiler with the eccentric-swirl-secondary-air combustion technology are significantly reduced by above 42% and 32.5 to 20.7% at loads of 180, 250 and 300 MW e , respectively. [ABSTRACT FROM AUTHOR]

To burn anthracite and reduce NO x emissions, a new combustion system was applied to a 300 MW e Babcock & Wilcox (B&W) down-fired boiler that included overfire air (OFA) and a decreased flow area of the inner and outer secondary air ducts of the installed swirl burners. Industrial-scale measurements (adjusting OFA ratios from 15.4% to 22.6%) were conducted to evaluate the overall performance of the retrofitted boiler. The experimental results demonstrated that the new combustion system promoted coal/air flow ignition and combustion stability. When the OFA ratio was less than 19.7%, the influence of the burner secondary air ratio on coal/air flow ignition was greater than that of the recirculation region below the arches. The overall combustion level in the primary combustion zone depended on the oxygen content and the recirculation region in the lower furnace instead of the early or late ignition of the coal/air flow. Oxygen and carbon monoxide concentration measurements in the near-sidewall region revealed that the fullness degree of the coal flame varied under different OFA ratios. Considering both environmental and economic effects, 19.7% was chosen as the optimal OFA ratio, thereby achieving a significant NO x reduction of 47% without increasing carbon content in the fly ash. [ABSTRACT FROM AUTHOR]