Search

Copper and zinc are essential trace elements participating in many physiological functions, notably immunity and protection against oxidative stress. Yeasts and the yeast Saccharomyces cerevisiae, in particular, possess in their genome tandem repeats of the CUP1 gene coding for a protein (a metallothionein) capable of capturing and binding toxic elements such as copper ions. The number of copies of this gene in a cell determines its physiological level of resistance to these ions. This paper describes the selection, characterization, and production of a new copper-resistant yeast strain that can bind large quantities of copper and zinc. This approach should lead to increasing the bioavailability of these trace elements and hence to reducing their emission into the environment.

Xylanase is produced by Penicillium canescens 10-10c from soya oil cake in static conditions using solid-state fermentation. The impact of several parameters such as the nature and the size of inoculum, bed-loading, and aeration is evaluated during the fermentation process. Mycelial inoculum gives more production than conidial inoculum. Increasing the quantity of inoculum enhances slightly xylanase production. Forced aeration induces more sporulation of strain and reduces xylanase production. However, forced moistened air improves the production compared to production obtained with forced dry air. In addition, increasing bed-loading reduces the specific xylanase production likely due to the incapacity of the Penicillium strain to grow deeply in the fermented soya oil cake mass. Thus, the best cultivation conditions involve mycelial inoculum form, a bed loading of 1-cm height and passive aeration. The maximum xylanase activity is obtained after 7 days of fermentation and attains 10,200 U/g of soya oil cake. These levels are higher than those presented in the literature and, therefore, show all the potentialities of this stock and this technique for the production of xylanase.

In this article, two theories are unified to investigate the effect of hydrodynamics on a specific bioprocess: the network-of-zones (NOZ) hydrodynamic structured modeling approach (developed by several researchers but applied to only a few bioprocesses) and the effectiveness factor eta approach. Two process scales were investigated (20 and 500 L), and for each, hydrodynamics were quantified using an NOZ validated by homogeneity time measurements. Several impeller combinations inducing quite different hydrodynamics were tested at the 20-L scale. After this step, effectiveness factors were determined for each fermentation run. To achieve this, a perfectly mixed microbial kinetic model was evaluated by using simple Monod kinetics with a fed-batch mass balance. This methodology permitted determination of the effectiveness factor with more accuracy because of the relation with the perfect case deduced from the Monod kinetics. It appeared that for the small scale, eta decreased until reaching a value of approx 0.7 (30% from the ideal case) for the three impeller systems investigated. However, stirring systems that include hydrofoils seemed to maintain higher effectiveness factors during the course of the fermentation. This effect can be attributed to oxygen transfer performance or to homogenization efficiency exhibited by the hydrofoils. To distinguish the oxygen transfer from the homogenization component of the effectiveness factor, these phenomena were analyzed separately. After determining the evolution of etaO2 linked to oxygen transfer for each of the fermentation runs, the NOZ model was employed to quantify substrate gradient appearance. After this step, another effectiveness factor, etamix, related to mixing was defined. Consequently, it is possible to distinguish the relative importance of the mixing effect and oxygen transfer on a given bioprocess. The results have highlighted an important scale effect on the bioprocess that can be analyzed using the NOZ model.