Search

The objective of this study was to determine the resilience, glass transition temperature (Tg), ultimate flexural strength (UFS), and penetration coefficient of 3 composite adhesives (Concise, Transbond, and Right On) and a glass ionomer cement (Fuji Ortho LC). For 25 minutes after initial set, the composite materials were significantly more resilient than Fuji Ortho LC (P = .000). Resilience values for all materials increased for up to 90 minutes after initial set, reflecting a continuation of their setting reaction. Right On remained the most resilient material at 90 minutes after initial set (P = .01). At 120 minutes, there was no significant difference in the resilience of Concise, Right On, and Fuji Ortho LC. However, Transbond was significantly less resilient than these materials (P = .01). The composite materials recorded significantly higher glass transition values (89-123°C) than Fuji Ortho LC (54°C). The composite materials were also significantly stronger (61-68 MPa) than Fuji Ortho LC (35 MPa) in flexion. The penetration coefficients of Concise and Transbond were significantly higher (P = .001) than Right On and Fuji Ortho LC. However, the relative penetration coefficients of the materials studied did not appear to influence the degree of bracket base penetration achieved by the cements. In conclusion, Fuji Ortho LC offered a reduced energy-absorbing capacity immediately after bracket placement and reduced cohesive and mechanical adhesive strength. In addition, the glass transition temperature of Fuji Ortho LC was low; this may result in compromised attachment at temperatures above 60°C. Significant differences in the penetration coefficient of the materials studied have been recorded. However, the penetration of the 4 cements into a range of bracket base morphologies was uniformly good. Therefore, the differences in penetration coefficient recorded should not influence the quality of the bracket cement interface provided. [ABSTRACT FROM AUTHOR]