Search

Pd-loaded FER and SSZ-13 zeolites as low-temperature passive NOx adsorbers (PNA) are compared under practical conditions. Vehicle cold start exposes the material to CO under a range of concentrations, necessitating a systematic exploration of the effect of CO on the performance of isolated Pd ions in PNA. The NO release temperature of both adsorbers decreases gradually with an increase in CO concentration from a few hundred to a few thousand ppm. This beneficial effect results from local nano-"hot spot" formation during CO oxidation. Dissimilar to Pd/SSZ-13, increasing the CO concentration above ≈1000 ppm improves the NOx storage significantly for Pd/FER, which was attributed to the presence of Pd ions in FER sites that are shielded from NOx. CO mobilizes this Pd atom to the NOx accessible position where it becomes active for PNA. This behavior explains the very high resistance of Pd/FER to hydrothermal aging: Pd/FER materials survive hydrothermal aging at 800 °C in 10 % H 2 O vapor for 16 hours with no deterioration in NOx uptake/release behavior. Thus, by allocating Pd ions to the specific microporous pockets in FER, we have produced (hydro)thermally stable and active PNA materials., (© 2021 Wiley-VCH GmbH.)

The analogy between single-atom catalysts (SACs) and molecular catalysts predicts that the specific catalytic activity of these systems is constant. We provide evidence that this prediction is not necessarily true. As a case in point, we show that the specific activity over ceria-supported single Pd atoms linearly increases with metal atom density, originating from the cumulative enhancement of CeO 2 reducibility. The long-range electrostatic footprints (≈1.5 nm) around each Pd site overlap with each other as surface Pd density increases, resulting in an observed deviation from constant specific activity. These cooperative effects exhaust previously active O atoms above a certain Pd density, leading to their permanent removal and a consequent drop in reaction rate. The findings of our combined experimental and computational study show that the specific catalytic activity of reducible oxide-supported single-atom catalysts can be tuned by varying the surface density of single metal atoms., (© 2021 Wiley-VCH GmbH.)

γ-alumina is one of the oldest and most important commercial catalytic materials with high surface area and stability. These attributes enabled its use as the first commercial large-scale heterogeneous catalyst for ethanol dehydration. Despite progress in materials characterization the nature of the specific sites on the surface of γ-alumina that are responsible for its unique catalytic properties has remained obscure and controversial. By using combined infrared spectroscopy, electron microscopy and solid-state nuclear magnetic resonance measurements we identify the octahedral, amphoteric (O) 5 Al(VI)-OH sites on the (100) segments of massively restructured (110) facets on typical rhombus-platelet γ-alumina as well as the (100) segments of irrational surfaces (invariably always present in all γ-alumina samples) responsible for its unique catalytic activity. Such (O) 5 Al(VI)-OH sites are also present on the macroscopically defined (100) facets of γ-alumina with elongated/rod-like geometry. The mechanism by which these sites lose -OH groups upon thermal dehydroxylation resulting in coordinatively unsaturated penta-coordinate Al +3 O 5 sites is clarified. These coordinatively unsaturated penta-coordinate Al sites produce well-defined thermally stable Al-carbonyl complexes. Our findings contribute to the understanding of the nature of coordinatively unsaturated Al sites on the surface of γ-alumina and their role as catalytically active sites., (© 2021 Wiley-VCH GmbH.)

We show for the first time that atomically dispersed Rh cations on ceria, prepared by a high-temperature atom-trapping synthesis, are the active species for the (CO+NO) reaction. This provides a direct link with the organometallic homogeneous Rh I complexes capable of catalyzing the dry (CO+NO) reaction. The thermally stable Rh cations in 0.1 wt % Rh 1 /CeO 2 achieve full NO conversion with a turn-over-frequency (TOF) of around 330 h -1 per Rh atom at 120 °C. Under dry conditions, the main product above 100 °C is N 2 with N 2 O being the minor product. The presence of water promotes low-temperature activity of 0.1 wt % Rh 1 /CeO 2 . In the wet stream, ammonia and nitrogen are the main products above 120 °C. The uniformity of Rh ions on the support, allows us to detect the intermediates of (CO+NO) reaction via IR measurements on Rh cations on zeolite and ceria. We also show that NH 3 formation correlates with the water gas shift (WGS) activity of the material and detect the formation of Rh hydride species spectroscopically., (© 2020 Wiley-VCH GmbH.)

High-temperature treatment of γ-Al 2 O 3 can lead to a series of polymorphic transformations, including the formation of δ-Al 2 O 3 and θ-Al 2 O 3 . Quantification of the microstructure in the range where δ- and θ-Al 2 O 3 are formed represents a formidable challenge, as both phases accommodate a high degree of structural disorder. In this work, we explore the use of an XRD recursive-stacking formalism for the quantification of high-temperature transition aluminas. We formulate the recursive-stacking methodology for modelling of disorder in δ-Al 2 O 3 and twinning in θ-Al 2 O 3 and show that explicitly accounting for the disorder is necessary to reliably model the XRD patterns of high-temperature transition alumina. We also use the recursive stacking approach to study phase transformation during high-temperature (1050 °C) treatment. We show that the two different intergrowth modes of δ-Al 2 O 3 have different transformation characteristics and that a significant portion of δ-Al 2 O 3 is stabilized with θ-Al 2 O 3 even after prolonged high-temperature exposures., (© 2020 Wiley-VCH GmbH.)

The application of single-atom catalysts (SACs) to high-temperature hydrogenation requires materials that thermodynamically favor metal atom isolation over cluster formation. We demonstrate that Pd can be predominantly dispersed as isolated atoms onto TiO 2 during the reverse water-gas shift (rWGS) reaction at 400 °C. Achieving atomic dispersion requires an artificial increase of the absolute TiO 2 surface area by an order of magnitude and can be accomplished by physically mixing a precatalyst (Pd/TiO 2 ) with neat TiO 2 prior to the rWGS reaction. The in situ dispersion of Pd was reflected through a continuous increase of rWGS activity over 92 h and supported by kinetic analysis, infrared and X-ray absorption spectroscopies and scanning transmission electron microscopy. The thermodynamic stability of Pd under high-temperature rWGS conditions is associated with Pd-Ti coordination, which manifests upon O-vacancy formation, and the artificial increase in TiO 2 surface area., (© 2020 Wiley-VCH GmbH.)

The majority of harmful atmospheric CO and NO x emissions are from vehicle exhausts. Although there has been success addressing NO x emissions at temperatures above 250 °C with selective catalytic reduction technology, emissions during vehicle cold start (when the temperature is below 150 °C), are a major challenge. Herein, we show we can completely eliminate both CO and NO x emissions simultaneously under realistic exhaust flow, using a highly loaded (2 wt %) atomically dispersed palladium in the extra-framework positions of the small-pore chabazite material as a CO and passive NO x adsorber. Until now, atomically dispersed highly loaded (>0.3 wt %) transition-metal/SSZ-13 materials have not been known. We devised a general, simple, and scalable route to prepare such materials for Pt II and Pd II . Through spectroscopy and materials testing we show that both CO and NO x can be simultaneously completely abated with 100 % efficiency by the formation of mixed carbonyl-nitrosyl palladium complex in chabazite micropore., (© 2018 Wiley-VCH Verlag GmbH & Co. KGaA, Weinheim.)

Side on! Combined FTIR and NMR studies revealed the presence of a side-on nitrosyl species in the zeolite Cu-SSZ-13. This intermediate is very similar to those found in nitrite reductase enzyme systems. The identification of this intermediate led to the proposal of a reaction mechanism that is fully consistent with the results of both kinetic and spectroscopic studies., (Copyright © 2013 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.)