Search

A shipboard fluorometric flow analyzer has been developed for near-real-time, high-resolution underway measurement of ammonium in seawater. The fluorometric method is based on the reaction of ammonium with o-phthaldialdehyde (OPA) and sulfite. The reagents used in this method have been modified to suit seawater analysis. This method shows no refractive index and salinity effect from seawater samples. The potential interferences in seawater have been studied, and their effects have been reduced. The instrument response is linear over a wide range of ammonium concentration. The limit of detection of 1.1 nM was estimated in laboratory using ammonium standards prepared in distilled water. It should be noted that application of this method to low-level ammonium measurement requires a correction of interference species, such as amino acids. The sample throughput is 3600 h(-1). The system can be used for both freshwater and seawater samples and has been used to monitor the distribution of ammonium in Florida coastal waters around an oceanic wastewater outfall.

We describe a robust, highly sensitive instrument for the determination of ambient ammonia. The instrument uses two syringe pumps to handle three liquids. The flow configuration is a hybrid between traditional flow injection (FI) and sequential injection (SI) schemes. This hybrid flow analyzer spends approximately 87% of its time in the continuous flow FI mode, providing the traditional FI advantages of high baseline stability and sensitivity. The SI fluid handling operation in the remaining time makes for flexibility and robustness. Atmospheric ammonia is collected in deionized water by a porous membrane diffusion scrubber at 0.2 L/min with quantitative collection efficiency, derivatized on-line to 1-sulfonatoisoindole, and measured by fluorometry. In the typical range for ambient ammonia (0-20 ppbv), response is linear (r2 = 0.9990) with a S/N = 3 limit of detection of 135 pptv (15 nM for 500 microL of injected NH4+(aq)) with an inexpensive light emitting diode photodiode-based detector. Automated operation in continuously repeated, 8-min cycles over 9 days shows excellent overall precision (n = 1544 p(NH)3 = 5 ppbv, RSD = 3%). Precision for liquid-phase injections is even better (n = 1520, [NH4+(aq)] = 2.5 microM, RSD = 2%). The response decreases by 3.6% from 20 to 80% relative humidity.

Techniques that have been variously termed oscillometric detection or (capacitively coupled) contactless conductivity detection (C(4)D) are known actually to respond to the admittance. It is not often appreciated that the frequency range (f) over which such systems respond (quasi)linearly with the cell conductance decreases acutely with increasing cell resistance. Guidance on optimum operating conditions for high cell resistance, such as for very small capillaries/channels and/or solutions of low specific conductance (σ), is scant. It is specially necessary in this case to take the capacitance of the solution into account. At high frequencies and low σ values, much of the current passes through the solution behaving as a capacitor and the capacitance is not very dependent on the exact solution specific conductance, resulting in poor, zero, or even negative response. We investigated, both theoretically and experimentally, capillaries with inner radii of 5-160 μm and σ ≈ 1-1400 μS/cm, resulting in cell resistances of 51 GΩ to 176 kΩ. A 400-element discrete model was used to simulate the behavior. As model inputs, both the wall capacitance and the stray capacitance were measured. The solution and leakage capacitances were estimated from extant models. The model output was compared to the measured response of the detection system over broad ranges of f and σ. Other parameters studied include capillary material and wall thickness, electrode spacing and length, Faraday shield thickness, excitation wave forms, and amplitude. The simulations show good qualitative agreement with experimental results and correctly predict the negative response behavior observed under certain conditions. We provide optimum frequencies for different operating conditions.